Delphi TC2708 Suspension Control Arm - Front Left Lower Forward

OE-Style Front Left Lower Forward Control Arm

Delphi TC2708 is a suspension control arm for the front left lower forward position on select Audi and Porsche applications. Built with steel and aluminum construction, it is a standard replacement part that follows OE-style dimensional and material analysis for proper fit and suspension geometry.

Compatible with 2011-2025 Audi A4, A4 Quattro, A4 allroad, A5, A5 Quattro, A6, A6 Quattro, A7 Quattro, A7, Q5, Q7, RS5, RS7, S4, S5, S7, SQ5, allroad, and 2015-2025 Porsche Macan, this Delphi TC2708 control arm supports front-end service on a wide range of European vehicles. This part cross-references MOOG Chassis Products RK641964 and Dorman OE Solutions 524-225 for the same application.

• Position: front left lower forward
• Material: steel and aluminum
• Construction: casting/forged
• Bushings included with rubber and aluminum bushing material
• Ball joint mounting type: press-in
• Mounting hardware included
• Non-adjustable, straight design
• Standard replacement grade

Detailed Product Overview

Delphi applies OE-focused engineering to this suspension control arm to help maintain alignment, steering response, and ride quality after replacement. The arm is finished in silver and uses black bushings with rubber bearing material for a direct-fit service part that matches the front left lower forward suspension location. Delphi also validates parts through temperature and corrosion testing, including exposure to extreme cold, high heat, and extended salt spray, to help confirm durability in demanding conditions.

Common Repair Applications

• Front suspension clunking or looseness from worn control arm bushings
• Uneven tire wear caused by suspension geometry changes
• Steering wander or reduced front-end stability
• Noise over bumps from deteriorated lower forward arm components
• Restoring OE-style suspension control on Audi A4, A5, Q5, and Porsche Macan models

Installation Notes and Tips

Install this control arm at the front left lower forward position only. Because the ball joint is not included and uses a press-in mounting type, verify the existing knuckle and related hardware before service. A professional alignment is recommended after installation to confirm camber and toe settings on Audi and Porsche front suspension systems.

Quality Assurance

Delphi uses OE dimensional and material analysis to support fitment accuracy and aftermarket compatibility. The part is tested for temperature extremes and salt-spray resistance to help verify performance in real-world suspension service.