Delphi TC2948 Suspension Control Arm - Rear Right Upper

OE-Style Rear Right Upper Control Arm

Delphi TC2948 is a standard replacement suspension control arm for the rear right upper position. It is built with pressed steel construction, rubber bushings, and OE-focused dimensional and material analysis for direct-fit compatibility on select Acura and Honda applications.

Key Features

• Pressed steel construction for the rear right upper suspension position
• Rubber bushings included for a complete arm assembly
• Standard replacement, regular grade design
• Non-adjustable layout for OE-style suspension geometry
• No ball joint included
• Delphi TC2948 is engineered using OE-level dimensional and material analysis

Application Details

Fits 1995-2001 Acura Integra, rear right upper. Fits 1997-2001 Honda CR-V, rear right upper. Fits 1997-2000 Acura EL, rear right upper. Fits 1988-2000 Honda Civic, rear right upper. Fits 1995-1997 Honda Civic del Sol, rear right upper. This part cross-references MOOG Chassis Products RK620048 for the same application.

For Acura Integra, Honda CR-V, Acura EL, Honda Civic, and Honda Civic del Sol suspension repairs, Delphi TC2948 provides an OE-style rear right upper control arm replacement that matches the original mounting position and suspension layout.

What This Part Helps Address

• Excessive rear suspension play from worn control arm bushings
• Clunking or knocking noises from the rear suspension area
• Uneven tire wear related to worn rear suspension geometry
• Loose or unstable rear-end handling caused by fatigued arm components
• Corrosion or structural wear in the original pressed-steel arm

Installation Notes

Install in the rear right upper position only and verify vehicle year, make, and model before ordering. Because this arm is non-adjustable and does not include a ball joint, confirm the existing suspension layout and inspect related mounting points, bushings, and fasteners during service. Professional alignment is recommended after installation to restore proper rear suspension geometry.

Quality Assurance

Delphi applies OE engineering practices to its aftermarket steering and suspension portfolio. This control arm is tested for temperature extremes below -40 degrees C and above 120 degrees C, and it is exposed to 720 hours of salt spray to evaluate durability and corrosion resistance. Delphi also uses dimensional and material analysis to support OE-to-aftermarket fit consistency.