Delphi TC3010 Suspension Control Arm - Rear Right Upper Rearward

OE-Style Rear Suspension Control Arm

Delphi TC3010 is a standard replacement suspension control arm for the rear right upper rearward position. It is built with steel and aluminum construction, rubber bushings, and a press-in ball joint mounting design to support precise rear suspension geometry on select Porsche, Volkswagen, and Audi applications.

Compatible with 2003-2006 Porsche Cayenne, 2008-2018 Porsche Cayenne, 2004-2017 Volkswagen Touareg, and 2007-2015 Audi Q7, this Delphi control arm is built for direct-fit service on the rear right upper rearward location. The TC3010 part number is a practical OE-style replacement for drivers restoring suspension response and alignment accuracy.

• Steel and aluminum construction with casting/forged design
• Rubber bushings included for rear suspension isolation
• Press-in ball joint mounting type
• Standard replacement grade for OE-style service
• Silver finish with gray bushings
• Not pre-greased; ball joint is not included
• Mounting hardware is not included

Detailed Product Overview

Delphi applies OE-focused dimensional and material analysis to its aftermarket steering and suspension portfolio, and this control arm reflects that approach. The combination of steel, aluminum, and rubber bushing materials helps maintain the rear suspension’s original geometry and ride characteristics on Porsche Cayenne, Volkswagen Touareg, and Audi Q7 platforms. Delphi TC3010 is cross-referenced in the aftermarket with Beck/Arnley 102-6982 and Dorman Premium CA43508PR for the same application.

Common Problems This Part Can Address

• Rear suspension looseness or clunking from worn control arm bushings
• Uneven tire wear caused by worn rear suspension geometry
• Alignment instability at the rear right upper rearward position
• Excess movement or noise from deteriorated rubber bushings
• Restoration of OE-style rear suspension response after wear

Installation Notes and Tips

Verify the rear right upper rearward position before installation and compare the original arm length, mounting points, and bushing orientation. Because the ball joint is not included and the unit is not pre-greased, inspect related suspension components and follow the vehicle manufacturer’s service procedure for torque specifications and alignment after replacement. This part number is TC3010.

Quality Assurance

Delphi tests its OE-based steering and suspension parts across extreme temperature and corrosion conditions, including sub-zero and high-heat exposure and extended salt-spray testing. That validation, along with dimensional and material analysis, supports consistent fitment and OE-style performance for the Delphi TC3010 control arm.