Delphi TC3376 Suspension Control Arm - Rear Left Upper Forward

OE-Style Rear Left Upper Forward Control Arm

Delphi TC3376 is a suspension control arm built for the rear left upper forward position on select BMW 7 Series models. It combines steel and aluminum construction with natural rubber bushings to support stable rear suspension geometry and consistent ride control.

Fits 2009-2012 BMW 750i, rear left upper forward. Fits 2010-2012 BMW 750i xDrive, rear left upper forward. Fits 2009-2012 BMW 750Li, rear left upper forward. Fits 2010-2012 BMW 750Li xDrive, rear left upper forward. Fits 2010-2012 BMW 760Li, rear left upper forward. Fits 2011-2012 BMW 740i, rear left upper forward. Fits 2011-2012 BMW 740Li, rear left upper forward.

Key Features

• Delphi TC3376 suspension control arm for rear left upper forward placement
• Steel and aluminum construction with casting/forged design
• Natural rubber bushings included for controlled suspension movement
• Standard replacement grade for OE-style service
• Silver finish with gray bushing color
• Not pre-greased and no ball joint included
• Not adjustable and no mounting hardware included

Detailed Description

Delphi applies OE-focused dimensional and material analysis to this control arm to help maintain proper fit and suspension alignment on BMW 740i, 740Li, 750i, 750Li, 750i xDrive, 750Li xDrive, and 760Li applications. The TC3376 uses a steel and aluminum body with natural rubber bushings to support rear suspension articulation while preserving the original mounting position. This part cross-references Beck/Arnley 102-8038 for the same application.

Common Repair Uses

• Rear suspension clunking or looseness from worn bushings
• Uneven tire wear caused by worn rear control arm components
• Rear-end instability or wandering during driving
• Suspension noise over bumps or rough pavement
• Restoring rear alignment control after component wear

Installation Notes and Tips

Replace the control arm in the exact rear left upper forward position and verify all suspension fasteners are torqued to BMW specifications during installation. Because this arm is not adjustable, a professional wheel alignment is recommended after replacement to confirm rear suspension geometry. Inspect adjacent bushings, links, and mounting points for wear before completing the repair.

Quality Assurance

Delphi tests suspension components for OE-level performance under extreme temperature and corrosion conditions, including sub-zero and high-heat exposure as well as extended salt-spray testing. The brand also uses detailed dimensional and material analysis to support OE-to-aftermarket fit consistency. Part number TC3376 is built as a standard replacement for the listed BMW 7 Series applications.