Delphi TC3464 Suspension Control Arm - Rear Forward

OE-Style Rear Forward Control Arm

Delphi TC3464 is a suspension control arm for the rear forward position on select Land Rover applications. Built from stamped steel with a black cataphoresis finish, it is engineered for standard replacement use on the Range Rover Evoque and LR2.

Delphi applies OE-focused dimensional and material analysis to help ensure proper fit and consistent suspension geometry. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Key Features

• Part number: TC3464
• Suspension control arm for rear forward placement
• Stamped steel construction for structural strength
• Black cataphoresis finish for corrosion resistance
• Natural rubber bushings included
• Press-in ball joint mounting type
• Standard replacement grade
• Not adjustable

Detailed Description

Delphi TC3464 is a rear forward suspension control arm engineered for 2012-2019 Land Rover Range Rover Evoque and 2008-2015 Land Rover LR2 models. The stamped steel body, rubber bearing type, and natural rubber bushings are specified to match OE-style suspension requirements, while the black finish helps protect the part in demanding underbody conditions. Delphi tests its steering and suspension components across extreme temperature ranges and salt-spray exposure to validate durability and dimensional consistency. If you are replacing a worn rear forward control arm on a Land Rover Range Rover Evoque or LR2, TC3464 provides a direct-fit replacement option built around OE reference data.

Common Issues This Part May Address

• Rear suspension clunking or knocking from worn bushings
• Excessive rear wheel movement caused by control arm wear
• Uneven tire wear related to suspension geometry changes
• Loose or unstable rear-end handling over bumps
• Noise from deteriorated rubber bushings in the rear forward arm

Installation Notes and Tips

Confirm the rear forward position before installation and compare the original arm to TC3464 for length, mounting-hole spacing, and bushing orientation. Because the ball joint is not included and the mounting hardware is not included, transfer or source the required components as needed for the vehicle. After installation, perform a wheel alignment to verify suspension geometry on the Range Rover Evoque or LR2.

Quality Assurance

Delphi uses OE-based engineering, dimensional analysis, and material validation to support fit and performance consistency. This control arm is exposed to extreme temperature testing and extended salt-spray evaluation during development to help verify durability in real-world suspension service.