Delphi TC3591 Suspension Control Arm - Front Right or Front Right Lower

OE-Style Front Right Control Arm

Delphi TC3591 is a standard replacement suspension control arm for the front right position. It is built with stamped steel construction, a coated black finish, and rubber bushings to support consistent suspension geometry on compatible Volkswagen applications.

Compatible With 2012-2022 Volkswagen Passat, front right and 2012-2015 Volkswagen Beetle, front right. Delphi applies OE dimensional and material analysis to help match the original part’s fit and function, and this control arm is tested for temperature extremes and salt-spray exposure.

Key Features

• Part number: TC3591
• Front right suspension control arm
• Stamped steel construction with coated finish
• Black arm and black bushings
• Rubber bushings included
• Standard replacement grade
• No ball joint included
• No grease fitting and not pre-greased
• No mounting hardware included

Detailed Product Overview

This Delphi control arm is engineered for OE-style replacement on Volkswagen Passat and Volkswagen Beetle front suspension applications. The stamped steel body and rubber bushings are selected for everyday road use, while the coated finish helps protect the part from corrosion exposure. Delphi’s OE-focused testing includes extreme temperature cycling and extended salt-spray exposure, along with dimensional and material analysis to support proper fitment. Part number TC3591 is also cross-referenced to Beck/Arnley 102-7909 for the same application.

Common Problems This Part Can Address

• Front-end clunking or looseness from worn suspension bushings
• Uneven steering response caused by a fatigued control arm
• Suspension geometry issues from a bent or corroded arm
• Excessive play in the front right lower suspension mounting point
• Ride quality concerns related to deteriorated rubber bushings

Installation Notes and Tips

Verify the vehicle’s front right suspension configuration before ordering, since fitment includes both front right and front right lower applications. Compare the original arm’s dimensions, mounting-hole spacing, and position to the OE part before installation. Because mounting hardware is not included, reuse or replace hardware as required by the vehicle service procedure. A professional alignment is recommended after installation to restore proper suspension angles.

Quality Assurance

Delphi uses OE safety technology and aftermarket engineering practices backed by dimensional and material analysis. This control arm is tested to withstand temperatures below -40 degrees C and above 120 degrees C, and it is exposed to 720 hours of salt spray for corrosion evaluation.