Delphi TC3595 Suspension Control Arm and Ball Joint Assembly - Front Left Lower

Front Left Lower Control Arm for Kia Soul

Delphi TC3595 is a front left lower suspension control arm and ball joint assembly for select 2010-2013 Kia Soul models. It is built as a standard replacement part with OE-focused dimensional and material analysis for consistent fit and suspension geometry.

Key Features

• Fits 2010-2013 Kia Soul, front left lower
• Stamped steel control arm construction with black finish
• Pre-greased assembly for service-ready installation
• Rubber bushings included
• Press-in ball joint with threaded stud
• Mounting hardware included
• Non-adjustable, non-greaseable design

Detailed Description

Delphi TC3595 is engineered for the front left lower position on the Kia Soul and is built to match OE-style dimensions and material requirements. Delphi subjects its steering and suspension components to extreme temperature cycling and extended salt spray exposure to help verify durability in demanding road conditions. The stamped steel arm, rubber bushings, and press-in ball joint design support a direct replacement for worn suspension hardware on 2010, 2011, 2012, and 2013 Kia Soul vehicles. This part cross-references MOOG Chassis Products RK642260 for the same application.

Common Problems This Part Can Address

• Clunking or knocking from the front suspension
• Excessive play in the lower control arm or ball joint
• Uneven tire wear caused by worn suspension geometry
• Steering looseness or wandering at the front end
• Cracked or deteriorated control arm bushings

Installation Notes and Tips

Replace the front left lower control arm when the ball joint or bushings show wear, or when suspension noise and alignment issues are present. Because this assembly uses a press-in ball joint and includes mounting hardware, verify all fasteners are torqued to factory specifications and perform a wheel alignment after installation. Confirm vehicle position before ordering: Fits 2010-2013 Kia Soul, front left lower.

Quality Assurance

Delphi applies OE engineering practices to its aftermarket steering and suspension portfolio, including dimensional and material analysis for fit consistency. The part is tested across extreme temperatures and salt spray exposure to support durability in real-world service.