Delphi TC3608 Suspension Control Arm and Ball Joint Assembly - Front Upper

OE-Style Suspension Control Arm

Delphi TC3608 is a front upper suspension control arm and ball joint assembly built for direct replacement applications. It is engineered for Toyota truck suspension service where dimensional accuracy and OE-style compatibility matter.

• Front upper control arm and ball joint assembly
• OE-focused dimensional and material analysis for accurate fit
• Tested for temperature extremes below -40 C and above 120 C
• Exposed to 720 hours of salt spray testing for corrosion resistance validation
• Delphi OE expertise applied to the aftermarket steering and suspension portfolio

Fitment and Application

Compatible with Toyota suspension applications listed below. Fits 1993-1998 Toyota T100, front upper. Fits 1990-1995 Toyota Pickup, front upper. Delphi TC3608 is a practical replacement choice when restoring steering response, suspension geometry, or worn joint performance on these Toyota models.

This part cross-references Dorman - OE Solutions (e.g., 520-084) for the same application.

What It Helps Address

• Excessive play in the upper suspension joint
• Uneven tire wear caused by worn suspension geometry
• Noisy or loose front-end handling
• Restoration of steering stability after component wear

Installation Notes and Quality

Install as a front upper suspension control arm and ball joint assembly using the correct service procedures for the vehicle. Verify alignment after replacement. Delphi applies OE-level dimensional and material analysis and extreme-environment testing to support consistent aftermarket fit and performance.