Delphi TC3814 Suspension Control Arm - Front Right Lower

OE-Style Front Right Lower Control Arm

Delphi TC3814 is a front right lower suspension control arm built for the 2007-2009 Volvo S60. It uses steel construction with a forged/cast design, rubber bushings, and a black cataphoresis finish for a direct OE-style replacement in the front suspension.

Delphi applies OE-level dimensional and material analysis to help ensure proper fit and consistent suspension geometry. This Delphi TC3814 control arm is engineered for the front right lower position on Volvo S60 applications and is tested for extreme temperature exposure and salt-spray resistance during development.

Key Features

• Part number: TC3814
• Front right lower suspension control arm
• Steel construction with casting/forged design
• Rubber bushings with black bushing color
• Black cataphoresis finish for corrosion resistance
• No ball joint included
• No mounting hardware included
• Non-adjustable design
• Direct replacement for select Volvo S60 models

Detailed Description

Delphi TC3814 is a suspension control arm for the front right lower position on 2007-2009 Volvo S60 models, with the 2007 application limited to vehicles from chassis #626502. Built from steel with a regular-grade forged/cast construction, it is designed to maintain suspension alignment and restore the original control-arm geometry. The rubber bushings help isolate road vibration while supporting stable front-end handling. This part cross-references Beck/Arnley 102-7599 for the same application.

What It Helps Address

• Excessive front suspension play
• Clunking or knocking from the lower control arm area
• Uneven tire wear caused by worn suspension geometry
• Steering pull or wandering at the front end
• Worn bushings affecting ride control

Installation Notes and Tips

Install TC3814 in the front right lower position only. Verify chassis number on 2007 Volvo S60 vehicles before ordering, since fitment begins at chassis #626502. Because mounting hardware is not included, inspect existing fasteners and related suspension components before installation. A professional alignment is recommended after replacement to confirm correct suspension angles and steering response.

Quality Assurance

Delphi uses OE-focused engineering and validation for its steering and suspension parts. This control arm is developed with dimensional and material analysis for OE-to-aftermarket compatibility and is subjected to temperature and salt-spray testing during product development.