Delphi TC3841 Suspension Control Arm - Front Left Lower

Delphi TC3841 Front Left Lower Control Arm

Delphi TC3841 is a steel suspension control arm with rubber bushings for the front left lower position. Built for OE-style fit and material consistency, it serves as a direct replacement for select Audi Q3, Volkswagen Arteon, and Volkswagen Tiguan applications.

Key Features

• Steel control arm construction
• Rubber bushings included
• Bolt-in mounting type
• Front left lower position
• Not pre-greased and no grease fitting included
• No mounting hardware included
• Non-adjustable design
• Control arm maximum length: 14.73 in. (374.1 mm)

OE-Style Replacement Design

Delphi TC3841 is engineered using dimensional and material analysis to match OE fitment expectations for the suspension system. Delphi subjects its steering and suspension components to extreme temperature cycling and extended salt-spray exposure to verify durability in demanding conditions. This part cross-references Mevotech Supreme CMS701166 for the same application.

Vehicle Fitment

• Fits 2019-2022 Audi Q3, front left lower.
• Fits 2019-2022 Volkswagen Arteon, front left lower.
• Fits 2018-2022 Volkswagen Tiguan, front left lower.

Common Issues This Part Addresses

• Excessive front-end looseness from a worn lower control arm
• Clunking or knocking from deteriorated suspension bushings
• Uneven tire wear caused by suspension geometry wear
• Steering instability during braking or cornering
• Suspension play at the front left lower mounting point

Installation Notes

Confirm the front left lower position before installation and compare the original arm length, bushing dimensions, and mounting style to the replacement part. Because mounting hardware is not included, reuse or source the correct hardware as needed. A professional alignment is recommended after installation on Audi Q3, Volkswagen Arteon, or Volkswagen Tiguan suspension repairs.

Quality Assurance

Delphi applies OE-focused engineering and validation to its aftermarket steering and suspension portfolio. TC3841 is built with steel construction and rubber bushings to support consistent fit and long-term service in the specified applications.