Delphi TC3965 Suspension Control Arm and Ball Joint Assembly - Front Right Lower

OE-Style Front Right Lower Control Arm

Delphi TC3965 is a front right lower suspension control arm and ball joint assembly for select 2007-2013 Nissan Altima models. Built with OE-focused dimensional and material analysis, it supports precise suspension geometry and consistent steering response on the Nissan Altima front right lower position.

Delphi applies OE safety technology and aftermarket steering expertise to this assembly, with testing that includes extreme temperature exposure and extended salt-spray resistance. The result is a premium replacement for drivers servicing a 2007-2013 Nissan Altima, front right lower suspension position.

Key Features

• Part number: TC3965
• Fits 2007-2013 Nissan Altima, front right lower
• Aluminum control arm construction with casting/forged design
• Ball joint included with press-in mounting type
• Pre-greased assembly with bushings included
• Dust boot included with chloroprene rubber construction
• Black rubber bushings and black boot color
• Uncoated finish with gray control arm color
• Premium grade replacement for power steering applications
• Mounting hole quantity: 2

Detailed Description

Delphi TC3965 is engineered as a direct replacement suspension control arm and ball joint assembly for the front right lower position on the 2007-2013 Nissan Altima. It combines an aluminum control arm with a press-in ball joint, rubber bushings, and a chloroprene rubber dust boot to restore suspension articulation and joint support in one service part. Delphi’s OE-based dimensional and material analysis helps maintain proper fit and alignment characteristics for the Nissan Altima front suspension.

This part cross-references MOOG Chassis Products RK620196 and Mevotech Supreme CMS30155 for the same application. Delphi TC3965 is a practical choice when replacing a worn front right lower control arm on a Nissan Altima and when restoring factory-style suspension feel matters.

What This Part Helps Address

• Front-end looseness from a worn lower control arm assembly
• Clunking or knocking from a deteriorated ball joint or bushings
• Uneven tire wear related to suspension geometry issues
• Steering wander or reduced road feel at the front suspension
• Noise and vibration from worn rubber suspension components

Installation Notes and Tips

Install on the front right lower suspension position only. Because the ball joint is press-in and the assembly is not greaseable, inspect surrounding suspension components, fasteners, and alignment settings during service. An alignment check after installation is standard practice for this type of repair. Mounting hardware is not included.

Quality Assurance

Delphi tests its OE-style steering and suspension components for temperature extremes below -40 degrees C and above 120 degrees C, along with 720 hours of salt-spray exposure. That validation supports consistent material performance and fit consistency for replacement service on the 2007-2013 Nissan Altima. Part number TC3965 reflects Delphi’s OE-focused approach to aftermarket suspension replacement.