Delphi TC4692 Suspension Control Arm and Ball Joint Assembly - Front Right Upper

Front Right Upper Control Arm for BMW M5 and M8

Delphi TC4692 is a front right upper suspension control arm and ball joint assembly built for select BMW performance sedans and coupes. It is a direct-fit replacement for applications including the BMW M5, BMW M8, and BMW M8 Gran Coupe, with OE-focused dimensional and material analysis for proper alignment and fit.

Key Features

• Front right upper suspension control arm and ball joint assembly
• Fits 2018-2023 BMW M5, front right upper
• Fits 2020-2025 BMW M8 Gran Coupe, front right upper
• Fits 2020 and 2022-2025 BMW M8, front right upper
• Engineered using OE-level dimensional and material analysis
• Tested for temperature extremes below -40°C and above 120°C
• Exposed to 720 hours of salt spray testing for corrosion resistance validation

Detailed Description

Delphi TC4692 is a suspension control arm and ball joint assembly for the front right upper position on select BMW M5, BMW M8, and BMW M8 Gran Coupe models. Delphi applies OE engineering knowledge to its aftermarket steering and suspension portfolio, helping ensure the part matches the original application’s geometry and material requirements. This part cross-references BMW 31 10 8 053 332 for the same application.

For drivers searching for a front right upper control arm for BMW M5 2018-2023, or a front right upper suspension control arm for BMW M8 and BMW M8 Gran Coupe applications, TC4692 provides a direct replacement option built around OE fitment standards. The assembly supports proper suspension location and ball joint articulation at the front corner of the vehicle.

What It Helps Address

• Excessive play or looseness in the front suspension
• Clunking or knocking from the front right upper suspension area
• Uneven tire wear caused by worn suspension geometry
• Steering pull or reduced front-end stability
• Ball joint wear affecting alignment and handling response

Installation Notes and Tips

Install TC4692 on the front right upper position only. After replacement, perform a professional wheel alignment to verify suspension geometry and steering wheel centering. Confirm vehicle application by year, model, and position before installation, especially on BMW M5, BMW M8, and BMW M8 Gran Coupe models.

Quality Assurance

Delphi validates this part through extreme-temperature testing and extended salt spray exposure, along with dimensional and material analysis to support OE-style fit and durability. Delphi’s OE safety technology is used on vehicles worldwide, and that engineering approach carries into this aftermarket suspension component.