Delphi TC5008 Suspension Ball Joint - Front Right

Front Right Suspension Ball Joint

Delphi TC5008 is a front right suspension ball joint built for OE-style replacement on select Lexus and Toyota applications. It combines a steel body, tapered threaded stud, and included dust boot to support precise steering and suspension movement in everyday driving.

Compatible with Lexus RX350, RX450h, RX350L, RX450hL, and Toyota Highlander, Sienna, and Venza front right applications, this Delphi ball joint is built to match OE dimensions and material requirements for proper fitment.

• Steel construction with black finish
• Front right position
• Ball joint assembly included
• Dust boot included; chloroprene rubber (CR) material
• Castle nut, cotter pin, nuts, and mounting hardware included
• Standard replacement grade
• Greaseable design not required; no grease fitting included
• Tapered threaded stud for secure suspension connection

OE-Style Fit and Construction

Delphi TC5008 is engineered using dimensional and material analysis to align with OE specifications, helping ensure proper compatibility between the original part and the aftermarket replacement. Delphi also subjects its steering and suspension components to extreme temperature and salt-spray testing, including exposure below -40 degrees C, above 120 degrees C, and 720 hours of salt spray. This part cross-references MOOG Chassis Products K500187 for the same application.

Fits 2017-2022 Lexus RX350, front right. Fits 2010-2015 Lexus RX350, front right. Fits 2018-2022 Lexus RX350L, front right. Fits 2010-2022 Lexus RX450h, front right. Fits 2018-2022 Lexus RX450hL, front right. Fits 2011-2020 Toyota Sienna, front right. Fits 2008-2019 Toyota Highlander, front right. Fits 2016 Lexus RX350, front right, Japan Built. Fits 2009-2016 Toyota Venza, front right.

Common Repair Uses

• Restores a worn or loose front suspension joint
• Addresses steering play or clunking from the front right corner
• Helps correct uneven tire wear caused by suspension looseness
• Replaces a damaged dust boot or corroded ball joint assembly
• Supports stable front-end alignment after suspension service

Installation Notes and Quality Assurance

Verify the vehicle’s front right application, including model year and build details, before installation. Inspect the steering knuckle, control arm, and mounting points for wear or damage, and follow the vehicle service procedure for torque and alignment checks after replacement. Delphi’s OE-focused testing and dimensional validation support consistent fit and performance for the listed Lexus and Toyota applications.