Delphi TC5152 Suspension Control Arm - Rear Rearward

OE-Style Rear Rearward Control Arm

Delphi TC5152 is a suspension control arm for the rear rearward position on select Subaru applications. Built with stamped steel construction, a black finish, and rubber bushings, it is a standard replacement part for restoring rear suspension geometry and ride control.

Compatible with 2000-2010 Subaru Outback, 1999-2009 Subaru Legacy, and 2003-2006 Subaru Baja in the rear rearward position. Delphi TC5152 is engineered using OE-focused dimensional and material analysis to support proper fit and consistent suspension performance.

• Stamped steel construction for strength and OE-style fit
• Black finish
• Rubber bushings included
• Bolt-in ball joint mounting type
• Standard replacement grade
• No grease fitting included
• Not adjustable

Detailed Product Overview

Delphi TC5152 is a rear rearward suspension control arm made for Subaru Legacy, Subaru Outback, and Subaru Baja applications that use this specific mounting position. The arm measures 437.0 in length and uses a stamped steel body with rubber bushings to help maintain suspension alignment and isolate road vibration. Delphi applies OE-level testing to temperature extremes and salt spray exposure to verify durability in demanding conditions. This part cross-references Dorman OE Solutions 524-191 and MOOG Chassis Products RK643085 for the same application.

What This Control Arm Helps Address

• Rear suspension looseness or clunking from worn arm bushings
• Uneven tire wear caused by suspension geometry issues
• Excessive rear-end movement over bumps and rough roads
• Alignment problems related to a worn rear rearward arm
• Noise from deteriorated suspension pivot points

Installation Notes

Install TC5152 in the rear rearward position only on the listed Subaru fitments. Verify the existing arm matches the stamped-steel, bolt-in design and confirm the vehicle’s year, model, and rear suspension configuration before installation. Mounting hardware is not included, so reuse or source the correct hardware as needed. After installation, a professional wheel alignment is recommended.

Quality Assurance

Delphi uses OE-based engineering and material analysis for aftermarket steering and suspension parts. TC5152 is tested for performance in extreme temperatures and extended corrosion exposure to support dependable service on Subaru Legacy, Subaru Outback, and Subaru Baja applications.