Delphi TC5215 Suspension Control Arm - Rear Left Lower

OE-Style Rear Left Lower Control Arm

Delphi TC5215 is a standard replacement suspension control arm built for the rear left lower position. It uses stamped steel construction with a black finish, rubber bushings, and a bolt-in ball joint mounting type for a direct-fit service part.

Compatible with 2006-2009 Kia Sedona and 2007-2009 Hyundai Entourage rear left lower applications, this Delphi control arm is built to match OE dimensions and material requirements for proper suspension geometry. The TC5215 is also a cross-reference for Beck/Arnley 102-5918 and Dorman OE Solutions 522-355 for the same application.

Key Features

• Delphi TC5215 suspension control arm for the rear left lower position
• Stamped steel construction with a black finish
• Rubber bushings included for suspension isolation
• Bolt-in ball joint mounting type
• Standard replacement item grade
• No grease fitting and no mounting hardware included
• Non-adjustable design for OE-style fitment

Detailed Description

Delphi applies OE-level dimensional and material analysis to its aftermarket steering and suspension parts, helping ensure proper compatibility with the original suspension layout. This rear left lower control arm is engineered for the Hyundai Entourage and Kia Sedona platforms listed below, making it a practical replacement when restoring rear suspension alignment and ride control. The TC5215 is built from steel with stamped construction and rubber bushings to support everyday driving demands.

Fits 2007-2009 Hyundai Entourage, rear left lower. Fits 2006-2008 Kia Sedona, rear left lower. Fits 2009 Kia Sedona, rear left lower without Electronic Stability Program. Part number TC5215 is the correct reference to verify before ordering.

Common Repair Uses

• Worn or cracked rear suspension bushings
• Excessive rear-end noise over bumps
• Loose or unstable rear suspension feel
• Incorrect rear wheel alignment caused by control arm wear
• Corrosion or fatigue in the original rear left lower arm

Installation Notes and Tips

Confirm the rear left lower position and verify vehicle configuration before installation, especially on 2009 Kia Sedona models without Electronic Stability Program. Inspect adjacent suspension components, alignment settings, and mounting points before replacing the arm. Because mounting hardware is not included, reuse or source the correct hardware as required by the vehicle service procedure.

Quality Assurance

Delphi tests suspension components for temperature extremes and extended salt-spray exposure, and uses OE-based dimensional and material analysis to support fit and durability. This part number, TC5215, is built as a standard replacement for the listed Hyundai Entourage and Kia Sedona applications.