Delphi TC5348 Suspension Control Arm - Rear Right

Rear Right Suspension Control Arm for OE Fit

Delphi TC5348 is a rear right suspension control arm for select Chevrolet, Buick, and Saab applications with trailing arm suspension. Built from stamped steel with rubber bushings and a bolt-in ball joint mounting type, it is a standard replacement part for restoring rear suspension geometry and ride control.

Fits 2014-2020 Chevrolet Impala, rear right; 2011-2017 Buick Regal, rear right; 2010-2016 Buick LaCrosse, rear right; 2016 Chevrolet Malibu Limited, rear right; 2013-2015 Chevrolet Malibu, rear right; 2010-2011 Saab 9-5, rear right; and 2010 Buick Allure, rear right.

• Delphi TC5348 rear right suspension control arm
• Stamped steel construction for OE-style strength and fit
• Rubber bushings included for suspension isolation
• Bolt-in ball joint mounting type
• Black finish with standard replacement grade
• No grease fitting, no adjustable feature, and no mounting hardware included

Application and Function

This control arm helps locate the rear suspension on vehicles using a trailing arm setup, supporting proper wheel alignment and stable handling. It is a direct-fit replacement for the rear right position on the Chevrolet Impala, Buick Regal, Buick LaCrosse, Chevrolet Malibu, Chevrolet Malibu Limited, Saab 9-5, and Buick Allure applications listed above. This part cross-references MOOG Chassis Products RK642852 for the same application.

Common Repair Uses

• Rear suspension noise from worn bushings
• Excessive play in the rear right suspension arm
• Uneven tire wear related to rear suspension movement
• Handling instability caused by a fatigued trailing arm
• Restoring factory rear suspension geometry after wear or corrosion

Installation Notes

Verify rear right fitment by year, make, model, and trailing arm suspension configuration before installation. Because mounting hardware is not included, reuse or replace fasteners as needed according to service procedures. Inspect adjacent bushings, links, and alignment settings during replacement, and perform a wheel alignment after installation if required by the vehicle service manual.

Quality Assurance

Delphi applies OE-level dimensional and material analysis to support proper part matching. This control arm is tested for extreme temperature exposure and salt-spray resistance to help validate durability in demanding underbody conditions.