Delphi TC5436 Suspension Control Arm - Front Right Lower

OE-Style Front Lower Control Arm

Delphi TC5436 is a stamped steel suspension control arm built for front lower applications on select Nissan Pathfinder and INFINITI QX4 models. It uses rubber bushings and a bolt-in ball joint mounting design to support precise front suspension service on the correct side of the vehicle.

This part cross-references MOOG Chassis Products RK640329 for the same application.

Key Features

• Stamped steel construction with a black finish
• Rubber bushings included for direct replacement service
• Bolt-in ball joint mounting type
• Standard replacement grade for front suspension repair
• No grease fitting and no mounting hardware included
• Length: 497.0

Detailed Description

Delphi TC5436 is engineered as a front lower suspension control arm for 1996-2004 Nissan Pathfinder, front right lower, and 1997-2003 INFINITI QX4, front right lower. Delphi applies OE-level dimensional and material analysis to help ensure proper fit and consistent suspension geometry, while the steel stamped construction is built for everyday road use. The rubber bushings help isolate vibration and support stable steering response in the front suspension.

For shoppers searching for a 1996-2004 Nissan Pathfinder front right lower control arm or a 1997-2003 INFINITI QX4 front right lower suspension arm, Delphi TC5436 provides a direct replacement option. The part number TC5436 is also a useful reference when comparing OE-style front suspension components for these vehicles.

What It Helps Repair

• Front-end clunking or looseness from worn control arm bushings
• Uneven tire wear caused by suspension geometry issues
• Steering wander or reduced directional stability
• Excess vibration transferred through the front suspension
• Wear-related replacement of the front lower control arm assembly

Installation Notes and Tips

Install on the specified position only: front right lower for the listed Pathfinder and QX4 applications. Verify vehicle year, make, model, and suspension position before installation. Because mounting hardware is not included, reuse or source the correct hardware as needed. After installation, a professional wheel alignment is recommended to restore proper suspension angles.

Quality Assurance

Delphi subjects steering and suspension components to extreme temperature and corrosion testing, including sub-zero and high-heat exposure plus extended salt spray testing. TC5436 is built to OE-style standards for dimensional accuracy and material compatibility in front suspension service.