Delphi TC5512 Suspension Stabilizer Bar Link - Front Left

Front Left Stabilizer Bar Link for Mazda CX-9

Delphi TC5512 is a front left suspension stabilizer bar link built for OE-style replacement on the Mazda CX-9. It uses a steel ball pin, steel housing, and a dust boot to support consistent sway bar connection and steering response in everyday driving.

Fits 2007-2015 Mazda CX-9, front left. Delphi applies OE dimensional and material analysis to help match the original part’s fit and function for this application.

Key Features

• Part number TC5512
• Front left stabilizer bar link for Mazda CX-9 models from 2007-2015
• Male M12 x 1.25 ends on both sides
• Steel ball pin and steel housing construction
• Dust boot included for added joint protection
• Polyoxymethylene (POM) bearing material
• Standard replacement, performance-grade design
• Locking nuts included
• Non-greaseable design

Detailed Description

Delphi TC5512 is a suspension stabilizer bar link for the front left position on the Mazda CX-9. It measures 135.0 mm in length, with a 99.5 mm distance between mounting holes, and uses male M12 x 1.25 threaded ends for direct replacement of the original linkage. The steel ball pin, steel housing, and POM bearing material are selected for durability in suspension service, while the included dust boot helps protect the joint from road contamination.

Delphi tests OE-style steering and suspension components across extreme temperature ranges and salt-spray exposure to verify material durability and dimensional consistency. This part cross-references MOOG Chassis Products K750160 for the same application. If you are replacing a worn front sway bar link on a Mazda CX-9, Delphi TC5512 provides a direct-fit service part for the front left side.

Common Problems This Part Can Address

• Clunking or rattling from the front suspension over bumps
• Excessive sway bar movement caused by a worn link joint
• Loose or imprecise front-end handling
• Noise from a damaged dust boot or contaminated joint
• Uneven stabilizer bar connection on the front left side

Installation Notes and Tips

Confirm the front left position and verify thread size, mounting-hole spacing, and overall length before installation. Inspect the sway bar and strut mounting points for wear or damage, and replace any worn hardware or mating components as needed. After installation, check fastener torque against the vehicle service information and road test the vehicle to confirm quiet operation.

Quality Assurance

Delphi uses OE engineering expertise and dimensional/material analysis to support fit and function in aftermarket steering and suspension parts. This stabilizer bar link is tested for temperature extremes and salt-spray exposure to help validate durability in real-world conditions.