Delphi TC5513 Suspension Stabilizer Bar Link - Front Right

OE-Style Front Right Stabilizer Link

Delphi TC5513 is a front right suspension stabilizer bar link built for the 2007-2015 Mazda CX-9. It is a standard replacement part engineered with OE-focused dimensional and material analysis for consistent fit and suspension response.

For shoppers searching for a front right sway bar link for Mazda CX-9 models, TC5513 provides a direct replacement option with the correct thread and mounting dimensions.

Key Features

• Front right suspension stabilizer bar link for 2007-2015 Mazda CX-9
• Male M12 x 1.25 ends on both sides
• Steel ball pin and steel housing for durability
• Dust boot included to help protect the joint
• Polyoxymethylene (POM) bearing material
• Locking nuts included
• Standard replacement, performance-grade construction
• Delphi part number TC5513

Detailed Description

Delphi TC5513 is a front right stabilizer bar link designed for the suspension system on the Mazda CX-9. It measures 135.0 mm in length, with a 99.5 mm distance between mounting holes, and uses male M12 x 1.25 threaded ends for proper alignment with the OE-style mounting points. The steel ball pin, steel housing, and POM bearing material support stable operation in everyday driving conditions.

Delphi applies OE-level dimensional and material analysis to help ensure the replacement part matches the original application. This part cross-references MOOG Chassis Products K750161 for the same application. Search terms such as Mazda CX-9 front right sway bar link, 2007-2015 Mazda CX-9 stabilizer link, and Delphi TC5513 front suspension link all point to this direct-fit replacement.

What It Helps Fix

• Front-end clunking or rattling over bumps
• Excessive sway bar movement at the front right corner
• Loose or worn stabilizer link joints
• Uneven suspension response during cornering
• Noise caused by a damaged dust boot or joint wear

Installation Notes

Fits 2007-2015 Mazda CX-9, front right. Verify thread size, mounting-hole spacing, and position before installation. The part uses male M12 x 1.25 ends and includes locking nuts; no bushings, washers, or bolts are listed for this part. Confirm the suspension side and OE-style dimensions match the vehicle before service.

Quality Assurance

Delphi tests steering and suspension components under extreme temperature and corrosion conditions, including sub-zero cold, high heat, and extended salt-spray exposure. TC5513 is built to support OE-style fit and material consistency for the Mazda CX-9 application.