Delphi TC5515 Suspension Stabilizer Bar Link - Front Right

Front Right Stabilizer Bar Link for Toyota Trucks

Delphi TC5515 is a front right suspension stabilizer bar link built for OE-style replacement on Toyota Sequoia and Toyota Tundra applications. It combines steel construction, rubber bushings, and a sealed dust boot to support consistent steering and suspension response.

Key Features

• Front right suspension stabilizer bar link for Toyota Sequoia and Toyota Tundra
• Steel ball pin and steel housing for durable service
• Natural rubber bushings with gray finish
• Dust boot, washers, and locking nuts included
• Male M14 x 1.5 end 2 thread specification
• Performance-grade, standard replacement design
• Delphi TC5515 cross-references Beck/Arnley 101-5886 and MOOG K750180 for the same application

Detailed Description

Delphi TC5515 is engineered as a front right stabilizer bar link for 2008-2022 Toyota Sequoia and 2007-2021 Toyota Tundra, with a separate 2012 Toyota Tundra application through 08/2013. The part is built with a steel ball pin, steel housing, and natural rubber bushings to match OE-style suspension geometry and connection feel. Delphi applies dimensional and material analysis to support fitment consistency between original equipment and aftermarket replacement parts, and its components are tested across extreme temperature and salt-spray exposure conditions.

This part number, TC5515, is a direct replacement choice for drivers addressing front-end suspension wear on Toyota Sequoia and Toyota Tundra models. The design includes a dust boot, washers, and locking nuts, along with a 129.0 mm overall length and 85.0 mm mounting-hole distance for accurate installation alignment.

What This Part Helps Address

• Clunking or knocking from the front suspension
• Excessive sway bar link play or looseness
• Uneven steering response over bumps and turns
• Worn bushings or damaged link joints
• Front right stabilizer bar connection wear on Toyota Sequoia and Toyota Tundra

Installation Notes and Tips

Verify front right position, thread size, and mounting dimensions before installation. The link uses a male M14 x 1.5 end and does not include bolts. Inspect adjacent sway bar and suspension components for wear before replacing the link, and confirm the 2012 Toyota Tundra build date because this application is listed through 08/2013 only.

Quality Assurance

Delphi uses OE-focused engineering and material analysis for aftermarket steering and suspension parts. TC5515 is tested for temperature extremes below -40 degrees C and above 120 degrees C, and for extended salt-spray exposure to support corrosion resistance in demanding driving conditions.