Delphi TC5516 Suspension Stabilizer Bar Link - Front Left

OE-Style Front Left Stabilizer Link

Delphi TC5516 is a front left suspension stabilizer bar link built for OE-style replacement on select Toyota trucks and SUVs. It is engineered for the front suspension on Toyota Sequoia and Toyota Tundra applications, with materials and dimensions matched for proper fit and consistent steering response.

Key Features

• Front left suspension stabilizer bar link for Toyota Sequoia and Toyota Tundra
• Steel ball pin and steel outer sleeve construction
• Natural rubber bushing with gray finish
• Dust boot, bushings, washers, and locking nuts included
• Male M14 x 1.5 end 2 thread
• Performance-grade, standard replacement part
• Delphi TC5516 cross-references MOOG Chassis Products K750179 for the same application

Detailed Description

Delphi TC5516 is a suspension stabilizer bar link for the front left position, made for 2007-2021 Toyota Tundra and 2008-2022 Toyota Sequoia, plus 2012 Toyota Tundra built to 08/2013. The link uses a steel ball pin, steel housing, and steel outer sleeve, with a natural rubber bushing and POM bearing material to support stable suspension movement and consistent bar connection. Delphi applies OE dimensional and material analysis to help match the aftermarket part to the original fit and function, and the component is tested for temperature extremes and salt-spray exposure.

This part number, TC5516, is a direct-fit style replacement for the front left stabilizer link location on Toyota Sequoia and Toyota Tundra models listed above. It is a practical choice when replacing a worn sway bar link that has developed looseness, noise, or reduced suspension control.

What It Helps Address

• Front-end clunking or rattling from a worn stabilizer link
• Excess play in the sway bar connection
• Uneven suspension response over bumps and turns
• Noise caused by deteriorated bushings or joint wear
• Restoring stable front suspension linkage on Toyota Tundra and Toyota Sequoia

Installation Notes and Tips

Install TC5516 at the front left suspension position only. Verify thread size, mounting-hole spacing, and overall dimensions against the original link before installation. Because this part uses a male M14 x 1.5 end and includes locking nuts, confirm the mating hardware and torque specifications for the vehicle before final tightening. For 2012 Toyota Tundra applications, confirm the build date is through 08/2013.

Quality Assurance

Delphi builds this stabilizer bar link using OE-focused engineering and validation methods. The part is evaluated for extreme temperature exposure and salt-spray resistance, and Delphi’s dimensional and material analysis supports accurate replacement fitment for the listed Toyota applications.