Delphi TC5522 Suspension Stabilizer Bar Link - Front Right

Delphi TC5522 Front Right Stabilizer Bar Link

Delphi TC5522 is a front right suspension stabilizer bar link built for OE-style replacement on select Lexus applications. It uses a steel ball pin, steel housing, and a POM bearing material to support consistent steering and suspension response.

Compatible with Lexus IS250, IS300, IS350, RC300, RC350, GS300, and GS350 front right applications, this Delphi stabilizer link is engineered with dimensional and material analysis to match OE fitment requirements.

Key Features

• Part number: TC5522
• Front right suspension stabilizer bar link
• Steel ball pin and steel housing
• POM bearing material for controlled articulation
• Dust boot included
• Washers included
• Locking nuts included
• Male M12 x 1.25 ends on both sides
• Standard replacement grade
• Non-greaseable design

Detailed Description

Delphi TC5522 is a suspension stabilizer bar link for the front right position, built for Lexus vehicles that require precise sway bar connection and stable suspension geometry. It measures 123.0 mm in length, with a 85.0 mm distance between mounting holes, and uses matching male M12 x 1.25 threaded ends for OE-style installation. The design includes a dust boot to help protect the joint, while the steel housing and ball pin support durability in demanding road conditions. This part cross-references Beck/Arnley 101-5600 for the same application.

Vehicle Fitment

• Fits 2016-2022 Lexus IS300, front right.
• Fits 2011-2022 Lexus IS350, front right.
• Fits 2016-2022 Lexus RC300, front right.
• Fits 2015-2022 Lexus RC350, front right.
• Fits 2013-2020 Lexus GS350, front right.
• Fits 2007-2011 Lexus GS350, front right.
• Fits 2006-2015 Lexus IS250, front right.
• Fits 2006 Lexus GS300, front right.

Common Issues This Part Can Address

• Front-end clunking over bumps or uneven pavement
• Excess sway bar movement from a worn link joint
• Loose or imprecise steering feel caused by suspension wear
• Noise from a damaged dust boot or joint wear
• Uneven suspension response at the front right corner

Installation Notes and Tips

Confirm the front right position before installation and verify thread size, mounting-hole spacing, and overall length against the removed part. Inspect the sway bar and strut mounting points for wear or damage before tightening the new link to specification. Because this is a non-greaseable stabilizer link, it is installed as a sealed replacement component.

Quality Assurance

Delphi applies OE-level dimensional and material analysis to its aftermarket steering and suspension parts. This stabilizer bar link is tested for temperature extremes below -40 degrees C and above 120 degrees C, and it is exposed to 720 hours of salt spray to evaluate corrosion resistance and durability.