Delphi TC5605 Suspension Control Arm - Rear Upper

OE-Style Rear Upper Control Arm

Delphi TC5605 is a rear upper suspension control arm built for 2007-2010 Ford Edge and 2007-2010 Lincoln MKX applications. It uses steel construction with rubber bushings to support rear suspension geometry and consistent handling response.

Delphi applies OE-focused dimensional and material analysis to help ensure proper fit and performance in the aftermarket. This rear upper control arm is a standard replacement for drivers servicing worn suspension components on the Ford Edge or Lincoln MKX.

Key Features

• Steel construction with casting/forged design
• Rear upper position for specified Ford and Lincoln applications
• Rubber bushings included
• Black finish with gray and black bushing color
• Standard replacement, performance grade
• Not pre-greased and no grease fitting included
• No ball joint included
• No mounting hardware included

Detailed Product Information

Delphi TC5605 is engineered as a rear upper suspension control arm for the Ford Edge and Lincoln MKX. The steel body and forged/cast construction provide a durable replacement structure, while the included rubber bushings help isolate road vibration and maintain suspension alignment characteristics. Delphi tests components across extreme temperature ranges and salt-spray exposure to support OE-level durability expectations in demanding conditions.

This part cross-references MOOG Chassis Products RK642097 for the same application. Delphi TC5605 is a direct-fit replacement choice for rear upper suspension service on 2007-2010 Ford Edge and 2007-2010 Lincoln MKX models.

Common Problems This Part Can Help Address

• Rear suspension clunking or knocking from worn control arm bushings
• Excessive rear-end looseness or unstable handling feel
• Uneven tire wear caused by suspension wear or geometry shift
• Visible cracking, separation, or deterioration in the original arm bushings
• Restoring rear upper suspension support on Ford Edge and Lincoln MKX vehicles

Installation Notes and Tips

Install Delphi TC5605 in the rear upper suspension position only. Because mounting hardware is not included, inspect the existing fasteners and replace any damaged hardware as needed. After installation, perform a wheel alignment to verify rear suspension geometry and tire wear settings.

Before installation, compare the original arm dimensions and bushing orientation to the replacement part. This helps confirm correct placement on 2007-2010 Ford Edge and 2007-2010 Lincoln MKX models.

Quality Assurance

Delphi uses OE-focused engineering, dimensional analysis, and material validation to support fit and durability in aftermarket steering and suspension parts. TC5605 is built to meet standard replacement expectations for rear upper suspension service.