Delphi TC5608 Suspension Stabilizer Bar Link - Front Left

Front Left Stabilizer Bar Link for Nissan and Infiniti

Delphi TC5608 is a front left suspension stabilizer bar link built for direct replacement on select Nissan and Infiniti applications. It combines a steel ball pin, steel housing, and performance-grade construction to support consistent sway bar connection and steering response.

Engineered with OE-focused dimensional and material analysis, this Delphi stabilizer link is tested for extreme temperature exposure and salt spray resistance to help maintain fit and function in demanding road conditions.

Key Features

• Front left suspension stabilizer bar link
• Delphi part number TC5608
• Steel ball pin with steel housing
• Polyoxymethylene (POM) bearing material
• Dust boot included for added joint protection
• Male end connections: M14 x 1.5 and M12 x 1.25
• Locking nuts included
• Standard replacement, performance grade

Detailed Description

Delphi TC5608 is a front left sway bar link designed for vehicles that need a precise OE-style suspension connection. It is compatible with select INFINITI Q50, Q60, Q70, Q70L, QX50, Q40, EX37, EX35, G37, G25, G35, M35h, M37, and M56 models, as well as the Nissan 370Z. This part cross-references MOOG Chassis Products K750194 for the same application.

Built with a steel ball pin and steel housing, TC5608 uses a POM bearing material and includes a dust boot to help protect the joint from contamination. The link measures 129.0 mm in length, 80.0 mm in width, and 119.0 mm in height, with a 77.0 mm distance between mounting holes. Delphi’s OE testing includes exposure to temperatures below -40 C and above 120 C, plus 720 hours of salt spray, supporting durability for everyday suspension service.

Common Issues This Part May Address

• Clunking or knocking from the front suspension
• Excessive sway bar play at the front left corner
• Loose or imprecise steering feel over bumps
• Uneven stabilizer bar movement caused by worn link joints
• Noise from a deteriorated dust boot or joint wear

Installation Notes and Tips

Install Delphi TC5608 on the front left position only. Verify end thread sizes, mounting-hole spacing, and overall dimensions against the removed part before installation. Because this stabilizer bar link uses male M14 x 1.5 and M12 x 1.25 ends, confirm the vehicle-side hardware matches the original configuration on your Nissan 370Z or INFINITI suspension setup.

For best results, inspect the sway bar bushings, control arm bushings, and adjacent steering components during replacement. If the original link shows joint looseness, torn boot material, or corrosion, replace it before it affects suspension noise and handling.

Quality Assurance

Delphi applies OE-level dimensional and material analysis to help ensure proper part matching between original equipment and aftermarket replacement. TC5608 is tested for temperature extremes and salt spray exposure to support long-term performance in front suspension service.