Delphi TC5808 Suspension Control Arm - Front Lower

OE-Style Front Lower Control Arm

Delphi TC5808 is a standard replacement suspension control arm for select Jeep Wrangler JK and Jeep Wrangler front lower applications. Built from stamped steel with a cataphoresis finish, it is made to match OE dimensions and material requirements for consistent suspension geometry and fit.

For Jeep Wrangler JK front lower control arm replacement, Delphi TC5808 brings OE-focused construction and dimensional accuracy to help restore proper front suspension operation. It is a direct-fit style part for the listed applications and uses natural rubber bushings for controlled movement at the mounting points.

Key Features

• Part number: TC5808
• Stamped steel construction
• Cataphoresis finish for added corrosion resistance
• Natural rubber bushings included
• Standard replacement grade
• Black finish and black bushings
• Not pre-greased
• Ball joint not included
• Mounting hardware not included
• Position: front lower

Detailed Description

Delphi TC5808 is engineered as a front lower suspension control arm for 2007-2017 Jeep Wrangler and 2018 Jeep Wrangler JK models. Delphi applies OE-level dimensional and material analysis to aftermarket steering and suspension parts, helping ensure the arm matches the intended mounting points and suspension layout. The steel stamped construction and rubber bushing design support stable front-end control while maintaining the factory-style ride characteristics expected in a Jeep Wrangler front lower control arm replacement.

This part cross-references MOOG Chassis Products RK621823 for the same application. If you are searching for a Jeep Wrangler JK front lower control arm or a Delphi TC5808 replacement control arm, this part is built for the listed OE-style fitment.

What It Helps Address

• Front suspension looseness or wandering
• Clunking or knocking from worn lower control arm bushings
• Uneven steering response caused by worn suspension geometry
• Excessive front-end movement under braking or acceleration
• Wear-related replacement of the front lower control arm assembly

Installation Notes and Tips

Verify the vehicle position before ordering, since this part is listed for front lower applications only. Compare the original arm length, mounting points, and bushing style to confirm match before installation. Because mounting hardware is not included, inspect existing fasteners and replace any worn or damaged hardware as needed during service.

After installation on a Jeep Wrangler or Jeep Wrangler JK, perform a professional alignment to confirm proper suspension geometry and steering tracking.

Quality Assurance

Delphi tests suspension components under extreme temperature and corrosion conditions, including sub-zero and high-heat exposure as well as extended salt spray testing. That OE-focused validation, combined with dimensional and material analysis, supports consistent fit and performance for the listed Jeep Wrangler JK and Jeep Wrangler applications.