Delphi TC5815 Suspension Control Arm - Front Right Lower

OE-Style Front Right Lower Control Arm

The Delphi TC5815 is a front right lower suspension control arm for select Toyota Sequoia and Toyota Tundra applications. Built from stamped steel with rubber bushings, it supports precise suspension geometry for everyday road use and replacement service.

Compatible with 2000-2003 Toyota Tundra, front right lower, 2001-2003 Toyota Sequoia, front right lower, and 2004 Toyota Sequoia or Toyota Tundra built to 09/2003, front right lower.

• Brand: Delphi
• Part number: TC5815
• Position: Front right lower
• Material: Steel
• Construction: Stamped
• Bushings included: Yes
• Bushing material: Rubber
• Item grade: Standard replacement
• Grade type: Performance
• Color: Black
• Bushing color: Black and gray
• Adjustable: No
• Ball joint included: No

Detailed Product Overview

Delphi applies OE-level dimensional and material analysis to its aftermarket steering and suspension portfolio, helping the TC5815 match the original fit and function expected on Toyota Tundra and Toyota Sequoia front suspension service. The stamped steel construction and rubber bushings are selected for standard replacement use where maintaining alignment and restoring suspension control are priorities. Delphi TC5815 is a direct replacement choice for front right lower control arm service on the listed Toyota applications.

This part cross-references MOOG Chassis Products (e.g., RK640435) for the same application.

Common Problems This Part Can Address

• Excessive front-end looseness or wandering
• Clunking or knocking from the lower suspension area
• Uneven tire wear caused by worn control arm bushings
• Steering pull related to worn front suspension components
• Loss of suspension geometry after bushing or arm wear

Installation Notes and Tips

Verify the vehicle build date before ordering, since 2004 Toyota Sequoia and 2004 Toyota Tundra applications are listed only through 09/2003. Inspect related suspension components, including the ball joint and mounting points, before installation. Because mounting hardware is not listed as included, reuse or replacement hardware should be confirmed separately during service.

Quality Assurance

Delphi subjects its OE-based suspension components to temperature extremes below -40 degrees C and above 120 degrees C, along with extended salt-spray exposure, to evaluate durability in demanding conditions. The TC5815 is built as a standard replacement control arm for consistent fitment and service performance on the specified Toyota vehicles.