Delphi TC5852 Suspension Control Arm - Front Right

Front Right Suspension Control Arm for Taurus and Sable

Restore front suspension geometry with this Delphi suspension control arm, part number TC5852. It is a standard replacement front right control arm built from stamped steel with rubber bushings for direct service on select Ford Taurus and Mercury Sable models.

Key Features

• Delphi TC5852 suspension control arm for the front right position
• Stamped steel construction with a black finish
• Rubber bushings included
• Bolt-in ball joint mounting type
• Non-adjustable, standard replacement design
• No grease fitting included
• No mounting hardware included

Detailed Description

Delphi TC5852 is engineered as a front right suspension control arm for 1998-2003 Ford Taurus and 1998-2003 Mercury Sable applications listed below. The steel, stamped construction supports consistent fitment, while the included rubber bushings help isolate road vibration in everyday driving. Delphi applies OE-focused dimensional and material analysis to help match aftermarket fitment to the original part, and its steering and suspension components are tested across extreme temperature and salt-spray exposure conditions.

This part cross-references MOOG Chassis Products RK80411 for the same application.

What This Part Helps Address

• Front-end looseness or wandering caused by a worn control arm
• Clunking or knocking from worn suspension bushings
• Uneven tire wear related to suspension geometry issues
• Steering pull or unstable road feel at the front right corner
• Replacement needs after corrosion or structural wear on the original arm

Installation Notes and Tips

• Fits 1998 Ford Taurus, front right, from 05/13/1998.
• Fits 1998 Mercury Sable, front right, from 05/13/1998.
• Fits 1999-2002 Ford Taurus, front right.
• Fits 1999-2002 Mercury Sable, front right.
• Fits 2003 Ford Taurus, front right, to 08/04/2003.
• Fits 2003 Mercury Sable, front right, to 08/04/2003.
• Verify the vehicle build date and front right suspension configuration before installation.
• Inspect related bushings, ball joint wear, and alignment settings after replacement.

Quality Assurance

Delphi uses OE-oriented engineering, dimensional checks, and material analysis to support proper fit and consistent replacement performance. This TC5852 control arm is built for standard replacement service in the front suspension.