Delphi TC5853 Suspension Control Arm - Front Left

OE-Style Front Left Control Arm

Delphi TC5853 is a front left suspension control arm built for OE-style replacement on select Ford Taurus and Mercury Sable applications. It uses stamped steel construction with a black finish, rubber bushings, and a bolt-in ball joint mounting type for a direct-fit service part.

Fits 1998-2003 Ford Taurus, front left; fits 2004-2007 Ford Taurus, front left lower; fits 1998-2005 Mercury Sable, front left. Delphi TC5853 is engineered for the front left suspension position and follows OE dimensional and material analysis for application matching.

Key Features

• Stamped steel construction for standard replacement service
• Black finish
• Rubber bushings included
• Bolt-in ball joint mounting type
• No grease fitting included
• Non-adjustable design
• Front left position

Detailed Product Information

Delphi TC5853 is a suspension control arm for the front left side of the vehicle, with fitment covering 1998-2007 Ford Taurus and 1998-2005 Mercury Sable applications listed above. The steel, stamped construction and rubber bushing material are selected for standard replacement use, while the bolt-in ball joint mounting type supports OE-style serviceability. Delphi applies dimensional and material analysis to help maintain close OE-to-aftermarket matching, and the part is tested for temperature extremes and salt-spray exposure as part of its durability validation process. This part cross-references MOOG Chassis Products RK80412 for the same application.

Common Repair Uses

• Restoring front suspension geometry after wear or damage
• Replacing a control arm with deteriorated rubber bushings
• Addressing clunking or looseness from front left suspension wear
• Correcting steering feel affected by worn suspension pivot points
• Servicing OE-style front left lower suspension components on Taurus and Sable models

Installation Notes and Tips

Verify the vehicle year, make, model, and front left position before installation. Compare the original arm length, bushing layout, and ball joint mounting style to the replacement part number TC5853. Because mounting hardware is not included, reuse or source the required hardware separately as needed, and perform a professional alignment after installation.

Quality Assurance

Delphi uses OE-focused engineering practices for its steering and suspension portfolio, including dimensional and material analysis for fitment consistency. The part is validated through temperature cycling and extended salt-spray exposure testing to support durability in real-world service conditions.