Delphi TC655 Suspension Control Arm - Front Left Lower or Front Right Lower

OE-Style Front Lower Control Arm

Delphi TC655 is a stamped steel suspension control arm for front lower applications on select Volkswagen and Porsche models. It is built with rubber bushings, a coated black finish, and mounting hardware included for a direct replacement approach on the specified vehicles.

• Stamped steel construction with a coated finish
• Rubber bushings included for front suspension service
• Bolt-in ball joint mounting type
• Mounting hardware included
• Standard replacement grade for front left lower and front right lower positions
• Part number TC655 for application-specific ordering

Fitment and Application Details

Compatible with front lower suspension applications on 1980-1984 Volkswagen Jetta, 1980-1984 Volkswagen Rabbit Convertible, 1980-1983 Volkswagen Rabbit Pickup, 1985-1993 Volkswagen Cabriolet, 1983-1985 Porsche 944, and 1987-1988 Porsche 924. Use the vehicle application tab to confirm the exact side for your model. This Delphi TC655 control arm is also a fitment-based replacement for front left lower and front right lower positions on these vehicles.

Delphi applies OE-focused dimensional and material analysis to help match aftermarket fitment to the original part. The arm is tested for temperature extremes below -40 degrees C and above 120 degrees C, and it is exposed to 720 hours of salt spray during validation. This part cross-references MOOG Chassis Products RK641988 and Mevotech Supreme CMS70114 for the same application.

What This Control Arm Helps Address

• Front suspension looseness or wandering
• Clunking or knocking from worn lower arm bushings
• Uneven tire wear caused by worn suspension geometry
• Steering response issues related to front lower control arm wear
• Replacement needs after corrosion or stamped arm fatigue

Installation Notes

Confirm the vehicle’s exact front lower position before installation, since this part is listed for both front left lower and front right lower applications depending on model. Inspect related suspension components, alignment settings, and mounting points before final assembly. Because the ball joint is not included, transfer or replace the ball joint as required by the vehicle application.

Quality Assurance

Delphi builds this suspension control arm using OE-oriented engineering and validation methods, including dimensional and material checks for fit consistency. The part is tested under thermal and corrosion exposure conditions to support long-term service in demanding road environments.