Delphi TC6892 Suspension Stabilizer Bar Link - Front

OE-Style Front Stabilizer Bar Link

Delphi TC6892 is a front suspension stabilizer bar link built with OE-focused materials and dimensional analysis for accurate replacement fitment. It is engineered for Mercedes-Benz A220, A250, A35 AMG, CLA250, CLA35 AMG, CLA45 AMG, and GLB250 front applications from 2019-2021.

For shoppers searching for a front sway bar link for Mercedes-Benz A220 or a Delphi TC6892 replacement for a Mercedes-Benz CLA250 front suspension, this part is built to match the original mounting and performance profile.

• Ball joint ends at both sides for suspension articulation
• Front position application
• Steel housing for structural strength
• Polyoxymethylene (POM) bearing material
• Dust boot included to help protect the joint area
• Locking nuts included
• No greaseable fitting for maintenance-free service
• OE-focused design backed by Delphi dimensional and material analysis

Detailed Product Overview

Delphi TC6892 is a suspension stabilizer bar link designed for front-end control and consistent sway bar connection on select Mercedes-Benz models. Delphi applies OE engineering experience to its aftermarket steering and suspension portfolio, with testing that includes extreme temperature exposure from below -40 degrees C to over 120 degrees C and salt spray exposure for corrosion resistance validation. The result is a replacement link intended to preserve original suspension geometry and response on the Mercedes-Benz A220, A250, A35 AMG, CLA250, CLA35 AMG, CLA45 AMG, and GLB250.

This part cross-references Mevotech Supreme MS108290 for the same application. Delphi TC6892 is also associated with OE-style interchange references including 247-320-42-00 and A 247 320 76 03.

What This Part Helps Address

• Front-end clunking or knocking from a worn stabilizer link
• Excessive sway bar movement during cornering
• Loose or imprecise steering feel caused by joint wear
• Noise from deteriorated ball joints or protective boots
• Restoring proper front suspension connection on Mercedes-Benz models

Installation Notes

Install as a front stabilizer bar link on the confirmed vehicle applications only. Verify the existing link style, mounting points, and suspension layout before replacement. Because this part uses ball joint ends and includes locking nuts, clean the mounting surfaces and torque fasteners to the vehicle manufacturer’s specifications during installation.

Quality Assurance

Delphi validates this part through OE-oriented dimensional and material analysis, along with environmental testing for temperature extremes and salt exposure. That testing supports consistent fit and durability expectations for front suspension service on the listed Mercedes-Benz applications.