Delphi TC7105 Suspension Control Arm - Rear Left Lower or Rear Left Lower Forward

OE-Style Rear Lower Control Arm

Delphi TC7105 is a standard replacement suspension control arm for the rear left lower position on select Acura TL and Honda Accord applications. Built from stamped steel with pre-greased rubber bushings, it is made to restore stable rear suspension geometry and consistent handling response.

For shoppers searching for a rear left lower control arm for 1996-1998 Acura TL or a rear left lower forward control arm for 1990-1993 Honda Accord, Delphi TC7105 provides an OE-focused replacement backed by Delphi’s dimensional and material analysis.

Key Features

• Stamped steel construction for strength and OE-style fit
• Pre-greased design for ready-to-install service
• Rubber bushings included for suspension isolation
• Black finish and black bushing color
• Standard replacement grade for everyday repair work
• No ball joint included
• No grease fitting included
• No mounting hardware included

Product Details

Delphi TC7105 is engineered as a rear suspension control arm with a stamped steel body, 10.25 in. length, and 40.0 height. The arm uses rubber bushings and a pre-greased design to support smooth articulation and help maintain rear wheel alignment characteristics. Delphi applies OE-level dimensional and material analysis to improve part-to-vehicle compatibility, and the component is tested across extreme temperature ranges and salt-spray exposure to validate durability in demanding conditions. This part cross-references Dorman - OE Solutions 520-631 for the same application.

What It Helps Address

• Rear suspension looseness or wandering feel
• Clunking or knocking from worn control arm bushings
• Uneven rear tire wear caused by suspension wear
• Loss of rear alignment stability
• Excess movement in the rear left lower suspension point

Installation Notes

Fits 1996-1998 Acura TL, rear left lower. Fits 1990-1993 Honda Accord, rear left lower forward. Verify the exact rear position on the vehicle before installation, since this part is position-specific. Mounting hardware is not included, and the ball joint is not included. Because the arm is pre-greased and uses rubber bushings, installation should focus on correct alignment, torque, and final suspension settling after the vehicle is back on the ground.

Quality Assurance

Delphi uses OE-focused engineering practices for its aftermarket steering and suspension portfolio. TC7105 is evaluated for temperature resistance and salt-spray exposure, along with dimensional and material compatibility checks, to support consistent replacement quality.