Delphi TC7106 Suspension Control Arm and Ball Joint Assembly - Front Right Lower

Front Right Lower Control Arm for Mazda Protege

Delphi TC7106 is a standard replacement suspension control arm and ball joint assembly for the front right lower position. It is built for 1995-1998 Mazda Protege applications and supports OE-style fitment for drivers replacing worn front suspension components.

Key Features

• Standard replacement suspension control arm and ball joint assembly
• Fits the front right lower position
• Application-specific for 1995-1998 Mazda Protege
• Delphi OE-focused dimensional and material analysis for fit compatibility
• Tested for temperature extremes from below -40 C to over 120 C
• Exposed to 720 hours of salt spray during validation

Detailed Description

Delphi TC7106 is engineered for the front right lower suspension location on the 1995-1998 Mazda Protege. Delphi applies OE-based expertise to its aftermarket steering and suspension portfolio, using dimensional and material analysis to align the replacement part with the original application. The part number TC7106 is a direct reference for shoppers looking for a front right lower control arm and ball joint assembly for Mazda Protege models from 1995, 1996, 1997, and 1998. This part cross-references Dorman OE Solutions 520-880 for the same application.

What It Helps Address

• Excessive front-end looseness or play
• Clunking or knocking from the lower suspension area
• Uneven tire wear caused by worn suspension geometry
• Steering pull or unstable road feel
• Ball joint wear at the front right lower corner

Installation Notes and Tips

Fits 1995-1998 Mazda Protege, front right lower. Confirm the vehicle’s suspension layout and position before installation, and compare the existing assembly to Delphi TC7106 for match verification. Because this is a suspension control arm and ball joint assembly, a professional alignment is recommended after replacement.

Quality Assurance

Delphi validates this OE-style replacement through extreme-temperature testing and extended salt-spray exposure, along with dimensional and material analysis to support proper application fit and durability expectations.