Delphi TC7194 Suspension Control Arm - Rear Rearward

Delphi Rear Rearward Control Arm for Altima

Restore rear suspension geometry with this Delphi suspension control arm for the rear rearward position. Delphi applies OE-focused engineering and material analysis to help ensure proper fit and consistent performance on the 1998-2001 Nissan Altima.

• Steel construction for strength and durability
• Black finish
• Standard replacement, regular grade
• Mounting hardware included
• Not pre-greased
• No grease fitting, bushings, or ball joint included
• Non-adjustable design
• Position: rear rearward

OE-Style Suspension Replacement

Delphi TC7194 is built as a standard replacement control arm for rear suspension service on the Nissan Altima. It is engineered with OE compatibility in mind and tested across extreme temperature ranges and salt-spray exposure to support long-term durability in demanding road conditions. This part cross-references Dorman OE Solutions 522-412 for the same application.

Vehicle Fitment

• Fits 1998-2001 Nissan Altima, rear rearward.

Common Repair Symptoms

• Rear suspension looseness or wandering
• Clunking or knocking from the rear suspension
• Uneven tire wear caused by worn suspension geometry
• Excessive play in the rear control arm mounting points
• Handling instability over bumps and during cornering

Installation Notes

Confirm the rear rearward position before installation and compare the original arm length and mounting points to Delphi TC7194. Mounting hardware is included, but bushings and ball joint are not included, so inspect related suspension components before reassembly. Professional alignment is recommended after replacement to verify rear suspension settings.

Quality Assurance

Delphi uses OE-based dimensional and material analysis, along with temperature and corrosion testing, to support fit and durability in aftermarket steering and suspension service.