Delphi TC7341 Suspension Control Arm - Rear Left Upper

Rear Left Upper Control Arm for Mazda CX-7

Delphi TC7341 is a standard replacement suspension control arm for the rear left upper position on select Mazda CX-7 models. It is built using Delphi OE-focused dimensional and material analysis to support proper fitment and consistent suspension geometry on the 2007-2012 Mazda CX-7.

Key Features

• Standard replacement suspension control arm
• Fits the rear left upper position
• Application-specific for 2007-2012 Mazda CX-7
• OE-based dimensional and material analysis for fit consistency
• Tested for extreme temperature exposure and salt spray resistance
• Delphi part number TC7341

Detailed Description

Delphi TC7341 is a rear left upper suspension control arm engineered for the Mazda CX-7 platform. It is intended for 2007, 2008, 2009, 2010, 2011, and 2012 Mazda CX-7 models in the rear left upper position, making it a direct-fit suspension service part for restoring rear suspension alignment and control. Delphi applies OE-level engineering practices to its aftermarket steering and suspension portfolio, with validation that includes exposure to temperatures below -40 degrees C and above 120 degrees C, plus 720 hours of salt spray testing. This part cross-references Beck/Arnley 102-7643 for the same application.

What This Part Helps Address

• Rear suspension looseness or instability
• Excessive play in the rear left upper control arm location
• Uneven tire wear related to rear suspension geometry
• Clunking or knocking from worn suspension linkage
• Alignment issues after control arm wear or replacement

Installation Notes and Tips

Install Delphi TC7341 only on the rear left upper position specified for the Mazda CX-7. After replacement, perform a professional wheel alignment to verify rear suspension geometry and tire wear settings. Compare the removed part to the new control arm before installation to confirm correct application for your vehicle year and position.

Quality Assurance

Delphi uses OE-focused testing and dimensional analysis to support compatibility and performance consistency. The part is evaluated for extreme temperature exposure and salt spray resistance as part of Delphi's validation process for aftermarket steering and suspension components.