Delphi TC7422 Suspension Control Arm and Ball Joint Assembly - Front Right Lower

Front Right Lower Control Arm for Nissan Quest

Delphi TC7422 is a front right lower suspension control arm and ball joint assembly for select Nissan Quest models. Built as a standard replacement with an aluminum arm, pre-greased construction, and included bushings, it supports precise front suspension geometry for everyday driving.

Key Features

• Part number: TC7422
• Position: Front right lower
• Control arm material: Aluminum
• Control arm construction: Casting/forged
• Ball joint mounting type: Machined
• Ball joint stud type: Pinch
• Pre-greased design
• Bushings included with rubber bushing material
• Standard replacement grade
• Light suspension grade type

Detailed Description

Delphi TC7422 is engineered for the front right lower position on the Nissan Quest, covering 2011-2015 Nissan Quest, front right lower with bushing, and 2016-2017 Nissan Quest, front right lower. Delphi applies OE-level dimensional and material analysis to help ensure proper fit and consistent suspension performance. The aluminum control arm uses a casting/forged construction, while the machined ball joint mounting and pinch-style stud support accurate installation and secure attachment.

This part cross-references Beck/Arnley 102-7826 for the same application.

What It Helps Address

• Front-end looseness from a worn lower control arm
• Clunking or knocking from deteriorated bushings
• Uneven tire wear caused by suspension geometry issues
• Steering pull related to worn front suspension components
• Excess play in the front right lower suspension assembly

Installation Notes and Tips

Verify the vehicle is a 2011-2017 Nissan Quest before ordering, and confirm the front right lower position matches the existing suspension layout. This assembly is pre-greased and does not include mounting hardware or a grease fitting. Because the part is not adjustable, proper alignment should be checked after installation to restore suspension settings.

Quality Assurance

Delphi subjects steering and suspension components to extreme temperature testing below -40 degrees C and above 120 degrees C, along with extended salt-spray exposure and dimensional/material validation. These checks support OE-style fit and durability for the Nissan Quest front right lower application.