Delphi TC7451 Suspension Control Arm and Ball Joint Assembly - Front Right Lower

Front Right Lower Control Arm Assembly for Honda Odyssey

Delphi TC7451 is a front right lower suspension control arm and ball joint assembly built for 2014-2017 Honda Odyssey models. It combines an aluminum control arm, pre-greased ball joint, and included bushings to support precise front suspension service on the Odyssey.

Key Features

• Fits 2014-2017 Honda Odyssey, front right lower
• Delphi part number TC7451
• Aluminum casting/forged control arm construction
• Ball joint included with threaded stud design
• Pre-greased with dust boot included
• Bushings included, plus mounting hardware and locking nut included
• Black rubber bushings and chloroprene rubber dust boot
• Uncoated finish with gray control arm color
• Non-adjustable, greaseable: no

Detailed Description

Delphi TC7451 is an OE-style suspension control arm and ball joint assembly for the front right lower position on the 2014-2017 Honda Odyssey. Delphi applies OE dimensional and material analysis to help ensure proper part-to-vehicle matching, and the assembly is tested across extreme temperature and salt-spray exposure conditions to verify durability in demanding road environments. This part cross-references MOOG Chassis Products RK622210 for the same application.

The assembly uses an aluminum control arm with a threaded ball joint stud, rubber bushings, and a chloroprene rubber dust boot. It arrives pre-greased and includes the ball joint, bushings, mounting hardware, and locking nut for a complete suspension service replacement. Delphi TC7451 is a direct-fit option for drivers searching for a front right lower control arm assembly for Honda Odyssey, or a Delphi TC7451 replacement for 2014-2017 Honda Odyssey front suspension repair.

Common Issues This Part Can Help Address

• Front-end clunking or knocking from worn control arm bushings
• Excessive play from a worn ball joint
• Uneven tire wear related to suspension looseness
• Steering wander or reduced front-end stability
• Suspension noise during braking, turning, or road impacts

Installation Notes and Tips

Install this assembly in the front right lower position only. Verify mounting hole diameter, bushing dimensions, and ball joint orientation before installation. Because the unit is pre-greased and non-greaseable, no routine lubrication is required after installation. A professional alignment is recommended after replacing a control arm and ball joint assembly on a Honda Odyssey.

Quality Assurance

Delphi uses OE-focused engineering and material analysis for aftermarket steering and suspension parts. TC7451 is built to meet demanding temperature and corrosion exposure standards, supporting consistent performance in everyday driving and service conditions.