Delphi TC7635 Suspension Control Arm - Rear Left Forward

OE-Style Rear Left Forward Control Arm

Delphi TC7635 is a standard replacement suspension control arm for select Hyundai Accent applications. Built from stamped steel with a black cataphoresis finish, it is engineered for the rear left forward position and uses natural rubber bushings for controlled suspension movement.

Fits 2000-2006 Hyundai Accent, rear left forward. This Delphi TC7635 control arm is built to match OE dimensions and material requirements for direct replacement service on the Hyundai Accent.

Key Features

• Stamped steel construction for strength and consistent fit
• Black cataphoresis finish for added corrosion resistance
• Natural rubber bushings included
• Standard replacement design for the rear left forward position
• Non-adjustable, straight-arm layout
• Delphi part number TC7635

Detailed Description

Delphi TC7635 is a suspension control arm designed for the rear left forward location on select Hyundai Accent models. It measures 409.0 in length with a straight shape and stamped construction, and it uses rubber bearing material with black natural rubber bushings to support suspension articulation while maintaining OE-style geometry. Delphi applies dimensional and material analysis to help ensure proper part-to-vehicle compatibility, and each unit is tested across extreme temperature and salt-spray conditions to validate durability in demanding environments.

This part cross-references Dorman OE Solutions 522-923 for the same application.

What It Helps Address

• Excessive rear suspension looseness or wandering
• Clunking or knocking from the rear left forward suspension area
• Uneven tire wear caused by worn control arm bushings
• Loss of stable rear suspension alignment
• Cracked or deteriorated OE control arm bushings

Installation Notes and Tips

Install Delphi TC7635 in the rear left forward position only. Mounting hardware is not included, and the ball joint is not included. Because this is a non-adjustable stamped steel control arm, verify the vehicle application and suspension position before installation. A professional alignment is recommended after replacement to confirm rear suspension geometry.

Quality Assurance

Delphi uses OE-focused engineering, dimensional verification, and material analysis to support consistent aftermarket replacement quality. The part is validated through temperature cycling from below -40 degrees C to over 120 degrees C and exposure to 720 hours of salt spray.