Delphi TC7801 Suspension Control Arm and Ball Joint Assembly - Front Right Lower

OE-Style Front Right Lower Control Arm

Delphi TC7801 is a front right lower suspension control arm and ball joint assembly built for standard replacement service. It is engineered for the Mazda 6 and Mazda CX-5 applications listed below, with OE-focused dimensional and material analysis to support proper fit and consistent suspension geometry.

For drivers searching for a front right lower control arm for 2014-2020 Mazda 6 or 2013-2016 Mazda CX-5, Delphi TC7801 provides a stamped steel construction with a press-in ball joint and included bushings.

Key Features

• Fits 2014-2020 Mazda 6, front right lower
• Fits 2013-2016 Mazda CX-5, front right lower
• Stamped steel control arm construction
• Press-in ball joint with grooved stud design
• Pre-greased for initial service
• Bushings included with natural rubber material
• Light suspension grade type
• Black finish
• Delphi TC7801 OE-style replacement part

Detailed Description

Delphi TC7801 is a standard replacement suspension control arm and ball joint assembly for the front right lower position. It uses stamped steel construction, a press-in ball joint, and natural rubber bushings to match the service requirements of the original suspension layout. Delphi applies OE-based dimensional and material analysis to help maintain correct alignment and suspension response on the Mazda 6 and Mazda CX-5 platforms listed here. This part cross-references Dorman - OE Solutions 520-340 for the same application.

Common Repair Applications

• Front-end clunking or looseness from worn control arm bushings
• Ball joint wear that affects steering feel and suspension control
• Uneven tire wear related to suspension geometry changes
• Noise over bumps from a fatigued lower control arm assembly
• Restoring front right lower suspension support on Mazda 6 and Mazda CX-5 models

Installation Notes and Tips

Install TC7801 at the front right lower suspension position only on the listed Mazda applications. Because the ball joint is press-in and mounting hardware is not included, verify the existing hardware condition before service and follow the vehicle manufacturer’s alignment procedure after installation. A professional wheel alignment is recommended any time a lower control arm assembly is replaced.

Quality Assurance

Delphi subjects steering and suspension components to extreme temperature and corrosion testing, including sub-zero and high-heat exposure plus extended salt-spray evaluation. That testing, along with OE-focused fit analysis, supports consistent aftermarket replacement quality for TC7801.