Delphi TC7889 Suspension Control Arm and Ball Joint Assembly - Front Right Lower

Delphi TC7889 Front Right Lower Control Arm

Delphi TC7889 is a front right lower suspension control arm and ball joint assembly built for OE-style replacement on select Ford Escape models. It combines a stamped steel arm, pre-greased construction, and a bolt-in ball joint design to support precise front suspension movement and consistent alignment geometry.

Fits 2013-2019 Ford Escape, front right lower.

Key Features

• Stamped steel control arm with black finish
• Pre-greased design for ready-to-install service
• Rubber bushings included
• Bolt-in ball joint mounting type with grooved stud
• Standard replacement grade for front suspension service
• Delphi part number TC7889

Detailed Description

This Delphi suspension control arm and ball joint assembly is engineered for the front right lower position on 2013-2019 Ford Escape applications. Delphi applies dimensional and material analysis to help ensure proper OE-to-aftermarket fit, while the steel stamped arm and rubber bushings provide a service-ready replacement for worn front suspension components. The TC7889 is a direct-fit style solution for Ford Escape front suspension repair where control arm wear, bushing deterioration, or ball joint looseness has affected handling or tire wear.

Delphi tests its OE-focused steering and suspension components under extreme temperature and corrosion conditions, including sub-zero cold, high heat, and extended salt spray exposure. This part cross-references Monroe Shocks & Struts (e.g., 1793236) for the same application.

Common Problems This Part Can Help Solve

• Clunking or knocking from the front right lower suspension
• Uneven tire wear caused by worn control arm bushings or ball joint play
• Loose or unstable steering feel on Ford Escape front suspension
• Alignment issues related to a fatigued lower control arm assembly
• Visible cracking, separation, or corrosion on the original arm

Installation Notes and Tips

Verify the front right lower position before installation and compare the original arm dimensions, bushing layout, and ball joint style to the replacement part. Because mounting hardware is not included, reuse or source the correct hardware as required by the vehicle service procedure. After installation on a Ford Escape, a professional wheel alignment is recommended to restore suspension geometry.

Quality Assurance

Delphi builds this TC7889 assembly using OE-oriented engineering and validation methods, including dimensional and material checks for fit consistency and durability testing for temperature and corrosion resistance. The result is a standard replacement control arm assembly intended to meet the demands of everyday suspension service on 2013-2019 Ford Escape models.