Delphi TC7904 Suspension Stabilizer Bar Link - Front

Front Stabilizer Bar Link for OE-Style Handling

The Delphi TC7904 is a front suspension stabilizer bar link built for OE-style replacement on select Hyundai and Kia applications. It uses a steel construction, includes a dust boot, and is engineered with Delphi’s OE-focused dimensional and material analysis for proper fit and consistent suspension response.

Fits 2019-2023 Kia Forte, front; Fits 2020-2023 Kia Forte5, front; Fits 2017-2022 Hyundai Ioniq, front; Fits 2018-2022 Kia Niro, front; Fits 2020-2022 Kia Niro EV, front; Fits 2016-2020 Hyundai Elantra, front; Fits 2017-2020 Hyundai Elantra GT, front; Fits 2019 Kia Niro EV, front; Fits 2017 Kia Niro, front.

Key Features

• Delphi TC7904 front suspension stabilizer bar link
• Steel construction for standard replacement service
• Dust boot included to help protect the joint area
• Locking nuts included
• M12 x 1.25 bolt thread size
• 295.0 mm mounting hole distance
• Front position application
• OE-focused fitment analysis for dimensional accuracy

Detailed Description

The Delphi TC7904 stabilizer bar link is a direct replacement suspension component for the front end of select Kia Forte, Kia Forte5, Hyundai Ioniq, Kia Niro, Kia Niro EV, Hyundai Elantra, and Hyundai Elantra GT models. Delphi applies OE engineering practices to its aftermarket steering and suspension portfolio, with testing that includes extreme temperature exposure below -40 degrees C and above 120 degrees C, plus 720 hours of salt spray exposure. This helps support durability in demanding road and weather conditions. This part cross-references MOOG Chassis Products K750890 for the same application.

What It Helps Address

• Front-end clunking or rattling from a worn stabilizer link
• Excessive sway bar movement during cornering
• Loose or inconsistent steering feel caused by suspension wear
• Noise from deteriorated link joints or protective boots
• Restoring proper front suspension connection on Hyundai and Kia vehicles

Installation Notes and Tips

Verify front-position fitment before installation and confirm bolt thread size M12 x 1.25 matches the vehicle mounting points. Inspect the sway bar and strut mounting areas for wear or damage before replacing the link. The dust boot is included, and locking nuts are included; bushings are not included. Professional installation and a final alignment check are recommended after suspension service.

Quality Assurance

Delphi uses OE-based dimensional and material analysis to support fit and function, and this part is tested for temperature extremes and corrosion exposure to meet demanding service conditions.