Delphi TC8070 Suspension Control Arm - Rear Upper

OE-Style Rear Upper Control Arm

The Delphi TC8070 is a rear upper suspension control arm built for precise OE-style replacement on select Hyundai applications. It is engineered with stamped steel construction, painted finish, and rubber bushings to support stable rear suspension geometry and consistent handling.

Fits 2013-2019 Hyundai Santa Fe, rear upper. Fits 2013-2019 Hyundai Santa Fe XL, rear upper. Delphi TC8070 is a direct-fit suspension control arm for drivers replacing worn rear upper components on these vehicles.

Key Features

• Stamped steel control arm construction
• Painted black finish for corrosion resistance
• Rubber bushings included
• Mounting hardware included
• Standard replacement grade
• Rear upper position
• Non-adjustable design
• Length: 12.62 in. (320.5 mm)
• Distance between mounting holes: 274.6 mm

Detailed Description

Delphi TC8070 is designed for rear upper suspension service on the 2013-2019 Hyundai Santa Fe and 2013-2019 Hyundai Santa Fe XL. The stamped steel arm uses rubber bushings to help maintain factory-style ride characteristics, while the painted finish and black components support long-term durability in underbody conditions. Delphi applies OE-level dimensional and material analysis to help ensure proper fit and compatibility with the original suspension layout. This part cross-references MOOG Chassis Products RK643325 for the same application.

Common Replacement Reasons

• Clunking or knocking from the rear suspension
• Excessive play in the rear upper control arm
• Uneven rear tire wear caused by worn suspension geometry
• Loose or unstable rear-end handling
• Cracked or deteriorated bushings

Installation Notes

Install TC8070 at the rear upper suspension location on the confirmed Hyundai Santa Fe or Santa Fe XL application. Verify alignment after replacement, since control arm service can affect rear suspension angles. Compare the original arm length, mounting-hole spacing, and bushing orientation before installation to confirm correct part selection.

Quality Assurance

Delphi subjects its OE-based steering and suspension components to extreme temperature and salt-spray testing, along with dimensional and material validation, to support consistent aftermarket performance. The TC8070 is built to align with OE fit and material expectations for the listed Hyundai applications.