Delphi TC8200 Suspension Ball Joint - Front Left Lower

Delphi TC8200 Front Left Lower Ball Joint

Delphi TC8200 is a premium suspension ball joint for the front left lower position. It is built as a bolt-in, standard replacement with a steel body, dust boot, and included mounting hardware for the specified applications.

Key Features

• Fits 2014-2019 Ford Escape, front left lower
• Fits 2013-2018 Ford Focus, front left lower
• Fits 2014-2016 Ford Transit Connect, front left lower
• Steel construction with a chloroprene rubber dust boot
• Ball joint assembly included
• Bolt-in mounting type with three mounting holes
• Grooved stud design
• Standard replacement, premium type
• Mounting hardware, washers, and nuts included
• Greaseable design not required; no grease fitting included

Detailed Description

Delphi TC8200 is engineered for front left lower suspension service on select Ford applications, including the Ford Escape, Ford Focus, and Ford Transit Connect. Delphi applies OE-level dimensional and material analysis to support proper fitment between the aftermarket part and the original suspension layout. The part is tested across extreme temperature ranges and salt-spray exposure to evaluate durability in demanding road conditions. Delphi TC8200 cross-references Monroe Shocks & Struts 172286 and 182286 for the same application.

What It Helps Address

• Excessive front-end looseness or play at the lower control arm connection
• Clunking or knocking from the front suspension over bumps
• Uneven steering response caused by worn ball joint components
• Suspension inspection failures related to joint wear or boot damage
• Restoration of proper front left lower suspension geometry on listed Ford models

Installation Notes and Tips

Verify the vehicle position before installation: front left lower. This part uses a bolt-in mounting style with three mounting holes, so confirm the mounting bolt dimensions and hole spacing against the original component before assembly. The dust boot is included, and the unit is supplied with mounting bolts, nuts, and washers as listed in the product data. Always inspect adjacent suspension components, alignment settings, and fasteners during replacement.

Quality Assurance

Delphi uses OE-focused engineering and validation for its steering and suspension portfolio. TC8200 is evaluated for temperature resistance below -40 degrees C and above 120 degrees C, along with extended salt-spray exposure, to support consistent performance in service.