Delphi TC8357 Suspension Stabilizer Bar Link - Front Right

Delphi TC8357 Front Right Stabilizer Link

Delphi TC8357 is a front right suspension stabilizer bar link built as a standard replacement for select Mercedes-Benz Sprinter applications. It uses ball joint ends, a steel housing, and a rubber dust boot to support consistent sway bar connection and steering response on the passenger side front suspension.

Key Features

• Part number: TC8357
• Front right suspension stabilizer bar link
• Ball joint ends on both sides
• Steel housing with rubber boot material
• Dust boot included
• Standard replacement grade
• Locking nuts and hardware included
• Non-greaseable design
• Length: 170.18 mm (6.700 in.)
• Distance between mounting holes: 138.00 mm

Detailed Description

Delphi TC8357 is engineered for the front right position on Mercedes-Benz Sprinter 2500, Sprinter 3500, and Sprinter 3500XD models listed below. Delphi applies OE-level dimensional and material analysis to help ensure proper fitment, and the part is tested across extreme temperature and corrosion conditions to verify durability in demanding suspension service. This part cross-references MOOG Chassis Products K750957 and Mevotech Supreme MS108223 for the same application.

Compatible With: Fits 2015-2021 Mercedes-Benz Sprinter 2500, front right; Fits 2015-2021 Mercedes-Benz Sprinter 3500, front right; Fits 2018-2019 Mercedes-Benz Sprinter 3500XD, front right. Delphi TC8357 is a direct-fit suspension stabilizer bar link for these front right applications on the Mercedes-Benz Sprinter platform.

What This Part Helps Address

• Clunking or knocking from the front suspension over bumps
• Excessive sway bar play at the front right corner
• Loose or worn ball joint connection in the stabilizer link
• Uneven steering feel caused by worn suspension linkage
• Corrosion-related wear on the original stabilizer bar link

Installation Notes and Tips

Install in the front right position only. Verify the mounting-hole spacing, overall length, and end type before installation to confirm the correct replacement for your Mercedes-Benz Sprinter 2500, Sprinter 3500, or Sprinter 3500XD. Because this link uses ball joint ends and includes locking nuts, proper torque and alignment checks after installation are recommended.

Quality Assurance

Delphi subjects this steering and suspension component to temperature extremes below -40 degrees C and above 120 degrees C, along with extended salt-spray exposure, to evaluate corrosion resistance and long-term performance. The TC8357 is built using OE-focused engineering methods for consistent aftermarket replacement quality.