Delphi TC8402 Suspension Stabilizer Bar Link - Front

Front Stabilizer Bar Link for Wrangler

Delphi TC8402 is a front suspension stabilizer bar link built for the 2018-2024 Jeep Wrangler. It combines a ball joint on one end with a bushing on the other to support front sway bar connection and consistent suspension response.

OE-focused materials and dimensional checks help this Delphi TC8402 front sway bar link match the original application on Jeep Wrangler models from 2018 through 2024.

Key Features

• Front suspension stabilizer bar link for Jeep Wrangler
• Ball joint end and bushing end construction
• Steel housing with rubber bushing material
• Dust boot included to help protect the joint area
• Locking nuts included
• Standard replacement grade
• Non-greaseable design
• Length: 6.780 in. (172.30 mm)

Detailed Description

Delphi TC8402 is engineered as a front stabilizer bar link for the Jeep Wrangler, covering 2018-2024 model years. Delphi applies OE-level dimensional and material analysis to support proper fit between the replacement part and the original suspension layout. The link uses a ball joint at one end and a bushing at the other, with a steel housing, rubber bushing material, and a POM bearing material for the joint assembly. The black bushing, dust boot, and included locking nuts round out the service-ready design. This part cross-references MOOG Chassis Products K700908 for the same application.

Common Problems This Part Can Address

• Front sway bar link noise over bumps or uneven pavement
• Excessive play in the stabilizer bar connection
• Clunking or rattling from worn front suspension linkage
• Reduced front-end stability from a deteriorated link assembly
• Visible wear, cracking, or separation at the bushing or joint

Installation Notes and Tips

Fits 2018-2024 Jeep Wrangler, front. Verify the mounting-hole spacing, overall length, and end styles before installation. Because this link is non-greaseable, routine service is limited to inspection and replacement when wear appears. Confirm the front position and compare the original part to Delphi TC8402 before final assembly.

Quality Assurance

Delphi subjects its OE-based steering and suspension components to temperature extremes below -40 degrees C and above 120 degrees C, along with extended salt-spray exposure testing. Delphi TC8402 is built using OE-focused dimensional and material analysis to support consistent replacement fit for Jeep Wrangler front suspension service.