Delphi TC8461 Suspension Ball Joint - Front Lower

OE-Style Front Lower Ball Joint

Delphi TC8461 is a front lower suspension ball joint built for the 2015-2021 Kia Sedona. It combines a steel body, rubber dust boot, and bolt-in mounting design to support precise suspension movement in a standard replacement format.

Delphi applies OE-focused dimensional and material analysis to its aftermarket steering and suspension parts, with testing that includes extreme temperature exposure and salt-spray durability. For shoppers searching for a Kia Sedona front lower ball joint or Delphi TC8461 replacement, this part is built around OE-style fit and material consistency.

• Brand: Delphi
• Part number: TC8461
• Position: Front Lower
• Material: Steel
• Suspension grade type: Standard Replacement
• Dust boot included: Yes
• Dust boot material: Rubber
• Mounting type: Bolt-In
• Mounting hardware included: Yes
• Mounting bolts included: Yes
• Grease fitting included: No
• Greaseable: No
• Adjustable: No
• Stud type: Grooved

Detailed Product Overview

Delphi TC8461 is engineered as a direct-fit front lower suspension ball joint for Kia Sedona models from 2015 through 2021. The steel construction, black finish, and included rubber dust boot help protect the joint assembly from road contamination while maintaining consistent suspension articulation. This Delphi TC8461 ball joint is a practical choice for restoring front-end geometry on a Kia Sedona with worn lower suspension components.

This part cross-references MOOG Chassis Products K500378 and Mevotech Supreme MS90523 for the same application.

What This Part Helps Address

• Front-end looseness or play from a worn lower ball joint
• Clunking or knocking noises from the front suspension
• Uneven tire wear related to suspension joint wear
• Steering wander caused by excess joint movement
• Restoration of proper front lower suspension articulation

Installation Notes and Tips

Compatible With 2015-2021 Kia Sedona, front lower. Verify mounting hole spacing, bolt diameter, and stud orientation before installation. Because this is a bolt-in design with mounting bolts included, replacement is typically performed by removing the worn assembly and securing the new joint to the original mounting points. Always inspect adjacent suspension parts, alignment settings, and fasteners during service.

Quality Assurance

Delphi uses OE-based dimensional and material analysis for aftermarket steering components and subjects parts to extreme temperature and corrosion testing, including exposure below -40 degrees C, above 120 degrees C, and 720 hours of salt spray. That testing supports consistent fitment and durability for the Kia Sedona front lower application.