Delphi TC8472 Suspension Stabilizer Bar Link Kit - Front Left

Delphi TC8472 Front Left Stabilizer Bar Link Kit

Delphi TC8472 is a front left suspension stabilizer bar link kit built for OE-style replacement on the Mazda MX-5 Miata. It uses ball joint ends, comes pre-greased, and includes a dust boot for added joint protection.

Engineered from Delphi OE expertise, this stabilizer link is built for the demands of daily driving and suspension movement. It is a direct-fit replacement for the front left position on 2016-2022 Mazda MX-5 Miata models.

Key Features

• Part number: TC8472
• Front left suspension stabilizer bar link kit
• Fits 2016-2022 Mazda MX-5 Miata, front left
• Ball joint ends on both sides
• Pre-greased for initial installation
• Dust boot included
• Standard replacement grade
• Chloroprene rubber (CR) boot material
• Polyoxymethylene (POM) bearing material
• Locking nuts included

Detailed Description

Delphi TC8472 is a suspension stabilizer bar link kit for the front left side of the Mazda MX-5 Miata. It is built as a standard replacement part with ball joint ends, a pre-greased design, and a protective dust boot to help maintain joint integrity. Delphi applies OE-level dimensional and material analysis to support proper fitment between the original and replacement part, and the component is tested across extreme temperature and salt-spray exposure conditions.

This part cross-references Mevotech Supreme MS76884 for the same application. If you are replacing a worn front sway bar link on a 2016-2022 Mazda MX-5 Miata, TC8472 provides a direct replacement option for the front left position.

What It Helps Address

• Clunking or rattling from the front suspension
• Excess play in the stabilizer bar connection
• Uneven response over bumps and turns
• Worn or damaged ball joint link ends
• Noise caused by a torn or missing dust boot

Installation Notes

Install at the front left suspension position only. Verify the vehicle application before installation and inspect the stabilizer bar, mounting points, and adjacent suspension components for wear. The link is pre-greased and includes locking nuts; grease fittings are not included. Professional installation is recommended for proper torque and alignment of the suspension hardware.

Quality Assurance

Delphi builds this stabilizer bar link using OE-focused engineering and material analysis to support fit and durability. The part is tested for extreme temperature exposure and salt-spray resistance to reflect demanding undercar conditions.