Delphi TC8913 Suspension Trailing Arm - Rear Lower Forward

Delphi Rear Lower Forward Trailing Arm

Delphi TC8913 is a stamped steel suspension trailing arm for the rear lower forward position. It is built as a standard replacement with rubber bushings installed, making it a direct service part for select Volvo rear suspension applications.

Key Features

• Stamped steel construction with a black finish
• Rear lower forward position
• Bolt-on mounting with bushing end design
• Rubber bushings included
• Standard replacement grade
• Not greaseable and no grease fitting included
• Mounting hole diameter: 12.20 mm
• Length: 374.00 mm (14.720 in.)

Fitment Details

• Fits 2019-2023 Volvo S60, rear lower forward.
• Fits 2017-2023 Volvo S90, rear lower forward.
• Fits 2019-2023 Volvo V60, rear lower forward.
• Fits 2018-2021 Volvo V90, rear lower forward.

This part cross-references Suspensia X53LA0541 and Delphi TC8913 for the same application.

Detailed Description

Delphi TC8913 is engineered for rear suspension service where the trailing arm locates and controls wheel movement at the rear lower forward position. The steel stamped construction and rubber bushings support a factory-style replacement for Volvo S60, Volvo S90, Volvo V60, and Volvo V90 applications listed above. Delphi applies dimensional and material analysis to help match OE fit and function, and its components are tested across extreme temperature and salt-spray exposure conditions to verify durability in demanding environments.

What It Helps Fix

• Rear suspension looseness or instability
• Clunking or knocking from worn trailing arm bushings
• Uneven rear tire wear caused by suspension movement
• Excessive rear wheel alignment shift from worn linkage
• Corrosion-related replacement needs on the original arm

Installation Notes and Tips

Confirm the rear lower forward position before ordering and compare the original arm length, mounting hole diameter, and bushing layout to the removed part. This is a bolt-on trailing arm with bushings included, and it does not include mounting hardware, so reuse or source the correct fasteners as needed. A professional alignment check after installation is recommended whenever rear suspension components are replaced.

Quality Assurance

Delphi builds this suspension trailing arm using OE-focused engineering and validation methods, including dimensional and material checks for fit consistency. The part is also evaluated under extreme temperature and salt-spray conditions to support long-term durability in real-world use.