Delphi TC8983 Suspension Control Arm - Front Right Lower

Front Right Lower Control Arm for Honda S2000

Delphi TC8983 is a front right lower suspension control arm for the Honda S2000. It is built for direct-fit replacement use on 2000-2009 Honda S2000 models with the front right lower position specified in the fitment data.

Key Features

• Front right lower suspension control arm application
• Fits 2000-2009 Honda S2000, front right lower
• OE-focused dimensional and material analysis for fitment consistency
• Tested for temperature extremes below -40 C and above 120 C
• Exposed to 720 hours of salt spray during validation testing
• Delphi TC8983 aftermarket steering and suspension replacement part

Detailed Description

Delphi TC8983 is engineered for the front right lower suspension position on the Honda S2000. Delphi applies OE-based expertise to its aftermarket steering and suspension portfolio, with attention to dimensional accuracy and material compatibility so the replacement part aligns with the original application. This part cross-references Beck/Arnley 102-7784 for the same application.

For Honda S2000 owners searching for a front right lower control arm replacement, Delphi TC8983 provides a direct-fit option for 2000-2009 vehicles. It is a practical choice when restoring suspension geometry, replacing worn pivot points, or addressing handling concerns tied to a damaged lower control arm.

Common Issues This Part May Address

• Clunking or knocking from the front suspension
• Uneven tire wear caused by worn suspension geometry
• Steering pull or reduced directional stability
• Excessive play in the front right lower suspension area
• Damage from impact, corrosion, or worn bushings and joints

Installation Notes and Tips

Verify the front right lower position before ordering and compare the existing control arm to the replacement part number TC8983. After installation, a professional wheel alignment is recommended to restore proper suspension angles and steering response. Confirm all mounting points and fastener condition during service, especially on higher-mileage Honda S2000 suspension systems.

Quality Assurance

Delphi validates this part through extreme-temperature testing and extended salt-spray exposure to support durability in demanding conditions. The brand also uses OE dimensional and material analysis to improve fit and application consistency for the Honda S2000 front right lower control arm.