Delphi TC9322 Suspension Control Arm and Ball Joint Assembly - Front Upper

Front Upper Control Arm for BMW 7 Series

Delphi TC9322 is a front upper suspension control arm and ball joint assembly for select BMW 7 Series applications. It is built for drivers replacing worn front suspension components on BMW 740i, 740Li, 750i, 750Li, 760Li, and ActiveHybrid 7 models.

Key Features

• Front upper suspension control arm and ball joint assembly
• Fits the front upper position on select BMW 7 Series vehicles
• OE-focused dimensional and material analysis for fitment alignment
• Engineered to handle extreme temperature exposure and salt spray testing
• Delphi part number TC9322 for direct catalog identification

Detailed Description

Delphi TC9322 is a suspension control arm and ball joint assembly designed for the front upper position on select BMW 7 Series models. Fits 2013-2015 BMW 740i, front upper; Fits 2015 BMW 740Ld xDrive, front upper; Fits 2013-2015 BMW 740Li, front upper; Fits 2013-2015 BMW 740Li xDrive, front upper; Fits 2013-2015 BMW 750i, front upper; Fits 2011-2015 BMW 750i xDrive, front upper; Fits 2011-2015 BMW 750Li, front upper; Fits 2013-2015 BMW 750Li xDrive, front upper; Fits 2013-2015 BMW 760Li, front upper; Fits 2013-2015 BMW ActiveHybrid 7, front upper. Delphi applies OE-based engineering to its aftermarket steering and suspension portfolio, with testing that includes sub-zero and high-heat exposure plus extended salt spray evaluation. This part cross-references BMW 31 12 6 854 614 for the same application.

Common Replacement Reasons

• Front suspension looseness or clunking over bumps
• Uneven tire wear caused by worn ball joint or arm bushings
• Steering wander or reduced front-end stability
• Excess play in the upper control arm assembly
• Inspection failure due to worn suspension components

Installation Notes and Tips

Confirm the vehicle’s model, drivetrain, and front upper suspension position before ordering. After installation, a professional wheel alignment is recommended to restore correct suspension geometry and steering response. Inspect adjacent suspension components for wear while the front upper control arm is removed.

Quality Assurance

Delphi uses OE-focused engineering, dimensional verification, and material analysis to support fitment consistency between original and aftermarket parts. The part is also validated through temperature and corrosion testing to help confirm durability in demanding service conditions.