Delphi TC9475 Suspension Control Arm - Rear Right Upper

Rear Right Upper Control Arm for Subaru

Delphi TC9475 is a rear right upper suspension control arm built for specific Subaru applications. It is an OE-style replacement for the 2005-2010 Subaru Outback and 2003-2006 Subaru Baja, with fitment focused on the rear right upper position.

Key Features

• Rear right upper suspension control arm application
• Fits 2005-2010 Subaru Outback, rear right upper
• Fits 2003-2006 Subaru Baja, rear right upper
• OE-focused dimensional and material analysis for application match
• Engineered and tested for temperature extremes and salt-spray exposure
• Delphi part number TC9475

Detailed Description

Delphi TC9475 is part of Delphi’s steering and suspension aftermarket portfolio, drawing on OE engineering experience used on millions of vehicles worldwide. For Subaru Outback and Subaru Baja rear suspension service, this control arm is built to match the original fit and material expectations of the OE application. Delphi validates components through extreme temperature testing and extended corrosion exposure to help maintain consistent performance in demanding conditions. If you are replacing a worn rear suspension control arm on a Subaru Outback or Subaru Baja, TC9475 provides a direct-fit service part for the rear right upper location.

This part cross-references Dorman - OE Solutions 527-208 for the same application.

What It Is Used For

• Replacing a worn rear right upper control arm on a 2005-2010 Subaru Outback
• Replacing a worn rear right upper control arm on a 2003-2006 Subaru Baja
• Addressing rear suspension looseness or play
• Correcting clunks, uneven tire wear, or alignment instability tied to control arm wear
• Restoring rear suspension geometry after component fatigue or corrosion

Installation Notes

Verify the rear right upper position before installation and compare the removed part to Delphi TC9475 for match confirmation. After replacement, a wheel alignment is recommended to confirm rear suspension geometry. Always check vehicle-specific service procedures and torque specifications during installation.

Quality Assurance

Delphi applies OE-based engineering, dimensional analysis, and material validation to its steering and suspension parts. TC9475 is tested for temperature exposure below -40 degrees C and above 120 degrees C, and for 720 hours of salt spray to evaluate durability in harsh environments.